Pages: [1]   Go Down

AuthorTopic: Diff backlash  (Read 1074 times)

0 Members and 1 Guest are viewing this topic.

Offline davidlandy

  • Posts: 3568
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Diff backlash
« on: July 06, 2005, 21:26:27 »
How do u remove or adjust out the backlash in a diff?

is it the sort of job u can do yourself or is it an 'ashcrofts' job?
Logged
Dave
Sniff, sniff, this mud smells funny

Offline beast5680

  • Regional Rep
  • *
  • Posts: 2938
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • hailsham east sussex
  • Referrals: 0
Diff backlash
« Reply #1 on: July 07, 2005, 13:04:06 »
its a case of shimming the crownwheel bearings and the pinion bearing to get it correct, it can be very tedious to do sometimes.
I,ve done them on plant and agricultural stuff before and some can be a right pain to get right
Logged
Neal

let him that hath understanding reckon the number of the beast

He, who laughs last, laughs best. He who laughs at Chuck Norris dies.

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
Diff backlash
« Reply #2 on: July 16, 2005, 02:12:29 »
Compard to a Ford 'English' axle the Rover diff is quite straightforward.  The pinion is adjsuted with shims and then the crownwheel mesh is adjusted by measuring the backlash at the circumfrence of the crownwheel with a DTI.

Perhaps not a job for the fainthearted though, why not buy a S/H one?
Logged
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.

Offline davidlandy

  • Posts: 3568
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Diff backlash
« Reply #3 on: July 16, 2005, 08:28:04 »
Quote from: "Range Rover Blues"
Compard to a Ford 'English' axle the Rover diff is quite straightforward.  The pinion is adjsuted with shims and then the crownwheel mesh is adjusted by measuring the backlash at the circumfrence of the crownwheel with a DTI.

Perhaps not a job for the fainthearted though, why not buy a S/H one?


sounds easier to dont it..

how much movement in degrees at the flange is acceptable?
Logged
Dave
Sniff, sniff, this mud smells funny
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal