Pages: [1]   Go Down

AuthorTopic: Vibration HELP  (Read 2353 times)

0 Members and 2 Guests are viewing this topic.

ben_haynes

  • Guest
Vibration HELP
« on: September 03, 2005, 23:55:52 »
just bought a 1990 200tdi disco and as i was driving today and it started to Vibrate through the steering / Pedals at about 60MPH. so i slowed down to around 50MPH and as i went over a rough section of road it started to do the same. but i can drive through it and it stops at about 65MPH

have had all four wheels balanced

What is the Cause / Fault?
Logged

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15221
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
Vibration HELP
« Reply #1 on: September 03, 2005, 23:59:09 »
Start by checking the propshafts, most likely the front.

The it's wheel bearings, diff etc etc for something that's probably bust.

If it was a V8 I'd also suggest a missfire.
Logged
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.

colintandy

  • Guest
shaking
« Reply #2 on: September 04, 2005, 00:21:42 »
hi ben i would agree with last gent check front propshaft uj and rear then have a check wheel bearings also check bushes and steering damper and track rod bar and ends the obviouse but easily missed check your tyre preasures and tyres it can all contrubute to that problem
did you get that from ray mate regards colin
Logged

TUFFTEE

  • Guest
Vibration HELP
« Reply #3 on: September 04, 2005, 09:02:32 »
I agree with RRB! But check your steering Damper1 Thats where my problem was! every time i touched a small bump in the road my steering went mental!!
Logged

Offline Budgie

  • Regional Rep
  • *
  • Posts: 2217
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • This post is best viewed on a computer.
    • Lochaber
  • Referrals: 0
Vibration HELP
« Reply #4 on: September 04, 2005, 10:48:07 »
The swivel housing pre-load could be another one to look at.
You can check this when you do the wheel bearings. Jack one front wheel off the ground, grab the tyre at the 6 & 12 o'clock positions and try to rock the wheel in & out. If you feel any movement then it could be the swivel pins that need a shim or two taking out.
If you do the same by grabbing the tyre at the 3 & 9 o'clock positions and get movement than look at wheel bearing.  :wink:
Logged

ben_haynes

  • Guest
Re: shaking
« Reply #5 on: September 04, 2005, 13:02:56 »
Thanks All will check it all out Today

Quote from: "colintandy"

did you get that from ray


Hi Colin

no i got it for £1000 with MOT till Nov and TAX till Dec

where as ray wanted one with No MOT and No TAX which needed some work for £1300

will pop round one of the days so you can tune it for me Although it goes well enought any way
Logged

TUFFTEE

  • Guest
Vibration HELP
« Reply #6 on: September 04, 2005, 13:06:09 »
Did he check out the one in the auctin forum which sold yesterday for £410? cheap or what!!
Logged

ben_haynes

  • Guest
Vibration HELP
« Reply #7 on: September 04, 2005, 13:40:48 »
no i didnt as i had already bought it whilst on holiday up in derbyshire
Logged

Offline davidlandy

  • Posts: 3568
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Vibration HELP
« Reply #8 on: September 04, 2005, 17:59:52 »
I would reckon on it being a UJ Ben

check em for play

good to hear you have a disco now , can you see over the steering wheel ok?
 :wink:
Logged
Dave
Sniff, sniff, this mud smells funny

ben_haynes

  • Guest
Vibration HELP
« Reply #9 on: September 04, 2005, 18:33:18 »
Quote from: "davidlandy"
can you see over the steering wheel ok?
 :wink:


Cheeky :lol:  :lol:
Logged
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal