Pages: [1]   Go Down

AuthorTopic: 200TDi axles  (Read 864 times)

0 Members and 1 Guest are viewing this topic.

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
200TDi axles
« on: November 11, 2005, 17:55:45 »
I'm trying to fit 200TDi half shafts in to my front axle but nothing seems to fit, so I've swapped the half shafts, stub axles, hubs and now I've got a wheel back on the centre cap pops off, so Does anybody have alloys on their 200TDi and if so which ones?
Logged
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.

Offline Xtremeteam

  • Regional Rep
  • *
  • Posts: 6476
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Its just the way i roll
    • lampeter, west wales
  • Referrals: 0
200TDi axles
« Reply #1 on: November 11, 2005, 18:46:02 »
does the hub have a slit stamped in the end of the studs?

If not shouldnt fit alloys to the motor
Logged
Mike
I can Drive.. You can criticize..
I too can criticize like you.. but can you Drive like me??

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
200TDi axles
« Reply #2 on: November 11, 2005, 20:45:13 »
Yes they have the slot marked on the end and on first glance they are the same as the RRC hubs, the studs are the same lenght, same castings, it's just the bearings sit further apart so I've had to swap the vented disks from the Rangie onto these hubs.
Logged
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal