can someone shed a bit of light plz

[landroverkeith]

afternoon all

just being a bit cheeky and asking if anyone here has a ford focus and or a haynes manual that could tell me how to get the passenger wing mirror assemble off cos i cant figure it out seems too tuff to force and dont wanna bust it as its me dads car and he is bigger then me lol

next time ill make him buy a landrover cos i know if it dont snap it eint right on them lol


cheers keith

[Andy the Landy]

I've a Focus and the manual - the manual is over at work - I'll have a look tomorrow . Is it electric mirror or manual :?:

[landroverkeith]

its electric andy :) tyvm

much appreciated

[Bush Tucker Man]

Which model is it?

I ask as the father-in-law has a mark 2 & I ought to be able to have a peek later.

[landroverkeith]

not sure wat model it is  buts a V reg focus ghia estate

thanks

[woody]

who would be daft enough to buy anything made by FORD  :lol:  :lol:

OH YE just realised ill get my coat :oops:  :oops:  :oops:
 

[Andy the Landy]

who would be daft enough to buy anything made by FORD  :lol:  :lol:

OH YE just realised ill get my coat :oops:  :oops:  :oops:
 

ME :lol:  :lol:

[dave_2A_2.25Turbo]

The fixing is behind the triangular black plastic trim on the inside of the door., behind a bit of sponge.  either 1 x 10mm or 3 x 7mm (can't remember when it changed). Depending on where the plug is, you'll probably have to take the door trim off.  V straightforward.

[mark.yellow.series.3]

F.O.R.D
fix, or, repair, daily

no offence    

[Andy the Landy]

According to Haynes.
Removal.
1. Disconnecct battery earth when electric mirror fitted.
2. Unclip quarter bezel from the front of the window opening and remove.
3. disconnect the wiring multi-plug from the mirror control switch.
4. Release the clip and detach the electrical connector to gain access to the retaining bolt.
5. Unscrew the mirror mounting bolt, then withdraw the mirror from the outside of the door. Recover the mirror seal as the wiring/cable is being drawn through the rubber grommet.

Refitting.
Refitting is a reversal of the removal procedure (but with grazed knuckles)

[Range Rover Blues]

I used to work for Ford, years ago in Product Development mainly and i'll tell you, there may be people ready to slag them off but there is a lot of s**t on the road that wouldn't be anywhere near good enough to wear the blue oval.  Some of the things we use to test for.........