AuthorTopic: Uprated springs or polybushes??  (Read 12451 times)

0 Members and 1 Guest are viewing this topic.

Offline Bob

  • Posts: 113
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Uprated springs or polybushes??
« on: August 28, 2003, 18:48:26 »
OK.  Having decided to go the jack-mates route for front recovery (thanks for all the replies) I now have another question.

As yet another birthday follows shortly after the LRO show at P'boro I have liberated sufficient funds to treat myself to either uprated springs (std ride height for towing) or orange polybushes.

Which would be the better way to go as I can't afford to do both just now.

Ta.
Bob
1994 300Tdi
DOC Member
Elddis Caravan Owners Club Member
www.elddisowners.co.uk

Offline Bush Tucker Man

  • Posts: 9161
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Uprated springs or polybushes??
« Reply #1 on: August 28, 2003, 19:33:32 »
I'll be keeping an eye on this one as well Bob, as I'll very shortly be in the market for new springs, shocks & probably bushes as well.
Again standard ride height, but possibly heavy-duty, and for same reasons as you - towing a 'Big White Shed On Wheels'

Does anyone know if the HD Discovery springs that John Craddocks advertise come in pairs, or as a set of 4? (like the Range Rover ones)
Richard A Thackeray 
Defender 110Td5 'Heritage Gone, but not forgotten
Jaguar XKR; X88 JLT, also 'gone, but not forgotten'

Yorkshire Born & Bred, and proud of it.

"You Can Allus Tell A Yorkshireman, But You Can't tell Him Owt!"

Offline George the Disco

  • Posts: 151
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Uprated springs or polybushes??
« Reply #2 on: August 29, 2003, 13:43:18 »
I'm running Deflex bushes which are rated between the orange and the red. Since they only cost iro £58 from Paddocks you should have some spending money left for springs  :D  8)

Chris
Now: 51 plate Freelander Commercial.
Then: G Reg 200tdi Disco, 182,500 miles, 35ish mpg, Stickers, Home made snorkle, Deflex Bushes, Blah, blah, blah...

Offline Bob

  • Posts: 113
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Uprated springs or polybushes??
« Reply #3 on: August 31, 2003, 19:08:21 »
Chris.

How long have you had the Deflex bushes fitted and how do you rate them.

I like the idea of having some cash now for springs as well  :D

Ta.
Bob
1994 300Tdi
DOC Member
Elddis Caravan Owners Club Member
www.elddisowners.co.uk

Offline George the Disco

  • Posts: 151
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Uprated springs or polybushes??
« Reply #4 on: September 01, 2003, 14:03:03 »
Fitted them in June. Seem to be very good although they are quite hard. Not that I can really judge what the feel like compaired to a standard 200tdi with new springs and shocks and 182.5k miles under its belt!

One thing I would say though and thats don't skimp when buying your shocks. I bought the cheapest (had to at the time) I could @ £15ea and they really aren't up to much.

Chris
Now: 51 plate Freelander Commercial.
Then: G Reg 200tdi Disco, 182,500 miles, 35ish mpg, Stickers, Home made snorkle, Deflex Bushes, Blah, blah, blah...

Offline johnknights

  • Posts: 99
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Uprated springs or polybushes??
« Reply #5 on: October 19, 2003, 08:25:11 »
I'm on 230,000 miles and I'm still on some original bushes, I have considered changing, but many of the people I have spoken to say they wish they hadn't, saying to harsh, etc. some have even tried various colours and said they were going back to original rubber next time.
I am on my third set of springs though, original set died after about 70K, replacement +2 inch HD set from a well known mail order company lasted better but after 100K looked like standard ones again, after a recomendation I have changed to the OME ones, got to say they are brill, still look like new after 50K, the guy who recommended them had done 100K on his, have now gone mad and bought the front shocks to replace the knackered 3 y/o decarbons, only snag is I like them that much I want the rear shocks changing too :-(
So my vote is buy decent springs, and leave the bushes til they are really knackered.
John

Offline George the Disco

  • Posts: 151
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Uprated springs or polybushes??
« Reply #6 on: October 19, 2003, 17:26:22 »
After 230K miles, I bet that they are noackered. mine were completely shot after 180K despite feeling ok when driving.

Chris
Now: 51 plate Freelander Commercial.
Then: G Reg 200tdi Disco, 182,500 miles, 35ish mpg, Stickers, Home made snorkle, Deflex Bushes, Blah, blah, blah...

Offline johnknights

  • Posts: 99
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Uprated springs or polybushes??
« Reply #7 on: October 26, 2003, 07:28:46 »
they get checked regularly at service, and if any need replacing then I get the whole of that "corner" done, so technically half have been replaced, but when I was asking around about rubber or poly bushes, a couple of the people I asked said they were going back to rubber ones.

Offline George the Disco

  • Posts: 151
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Uprated springs or polybushes??
« Reply #8 on: October 26, 2003, 10:40:52 »
I'm sure that I didn't type that word like that?  :?  :roll:
Now: 51 plate Freelander Commercial.
Then: G Reg 200tdi Disco, 182,500 miles, 35ish mpg, Stickers, Home made snorkle, Deflex Bushes, Blah, blah, blah...

Offline johnknights

  • Posts: 99
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Uprated springs or polybushes??
« Reply #9 on: October 29, 2003, 20:09:44 »
Don't worry I knew what you meant.
I have read somewhere that there is a rating sytem for bushes, bigger the number, the harder they are, I seem to remember that standard rubber ranks about 65 on the scale as do blue deflex, their were super flexi off road rated at about 50 and ultra hard fast road ones about 80 but I can't remeber the colour scheme dooh!

Offline davidlandy

  • Posts: 3568
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Uprated springs or polybushes??
« Reply #10 on: October 29, 2003, 20:21:34 »
I got blue ones from Bearmach - my view is that they are bushes, therefore they should give a little otherwise I might just as well weld up all the joints!!!

he he

Dave
Dave
Sniff, sniff, this mud smells funny

Offline Bush Tucker Man

  • Posts: 9161
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Durometer Scale (Rubber/Polymer Density)
« Reply #11 on: October 29, 2003, 23:00:27 »
Richard A Thackeray 
Defender 110Td5 'Heritage Gone, but not forgotten
Jaguar XKR; X88 JLT, also 'gone, but not forgotten'

Yorkshire Born & Bred, and proud of it.

"You Can Allus Tell A Yorkshireman, But You Can't tell Him Owt!"

Offline wifey

  • Posts: 372
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Uprated springs or polybushes??
« Reply #12 on: October 30, 2003, 09:43:38 »
Interesting diagram Ricahrd - wish I understood it :wink:
I think when I get mine done - probably in the spring or when I get the winch for the hole in the front bumbper - I'll do the lot. Which of course means waiting until I can afford it...
But surely, doing things in this area bit by bit isn't wise? Won't the bits then just wear out at different rates and b****r up the replacement schedule?
cheers! 8)
tina
Shiny Blue Crew Disco 200 Tdi J236 RVM
as yet unamed (aww!) Defender 90 2.25D E50 KEH
thrive under pressure and seize the day!
www.thriveunderpressure.com

Offline Bush Tucker Man

  • Posts: 9161
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Uprated springs or polybushes??
« Reply #13 on: October 30, 2003, 13:00:24 »
I don't believe that for a minute Tina, a very intelligent Lady like yourself ought to see the link contents for what they are.
It's simply a sliding scale of relative hardness/softness & the consequent items longetivity.

For example;
Shore A; the elastic band is a 30, it doesn't have to have a life/service expectancy.
The tyre is a 60, it has to be able to grip the road surface (not too hard a compound) and provide an economical service life.
That's unless it's needed for a special application, ie; Formula 1 ('the drive round in a circle gang') the slicks have acomparable rating to the pencil eraser(40)

Hope that's reasonably clear :)
Richard A Thackeray 
Defender 110Td5 'Heritage Gone, but not forgotten
Jaguar XKR; X88 JLT, also 'gone, but not forgotten'

Yorkshire Born & Bred, and proud of it.

"You Can Allus Tell A Yorkshireman, But You Can't tell Him Owt!"

Offline johnknights

  • Posts: 99
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Uprated springs or polybushes??
« Reply #14 on: December 26, 2003, 06:55:02 »
Great little drawing, unfortunately it still doesn't help me remember the colour coding  :wink:

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal