AuthorTopic: vibration  (Read 1805 times)

0 Members and 1 Guest are viewing this topic.

Offline chizy

  • Posts: 30
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Bloxham
  • Referrals: 0
vibration
« on: December 04, 2006, 15:11:08 »
Getting a vibration at about 30 mph which then disappears at 35 mph.Not there all the time only when accelerating,keeping to speed limit etc, goes when off the throttle.
Don't half make the top tailgate rattle when keeping to speed limit in town!!!
Suggestions??
300 Tdi with R380 by the way.

Thanks in advance

Offline sean m

  • Posts: 72
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
uj
« Reply #1 on: December 04, 2006, 16:44:01 »
Could be a prop shaft uj or balance problem had a similar problem rr mine was a uj

Offline L90OOK

  • Posts: 1252
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Somerset
  • Referrals: 0
vibration
« Reply #2 on: December 04, 2006, 17:04:37 »
Sounds like your front prop uj's.
Could be wheel alignment/balance...have you 'curbed' it recently?
Did everyone see that?  Because I will NOT be doing it again!

 

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
vibration
« Reply #3 on: December 04, 2006, 17:53:42 »
Nowt to say it's not the back prop either.

Let's see, does it vibrate a little at around 60 too?
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.

Offline chizy

  • Posts: 30
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Bloxham
  • Referrals: 0
vibration
« Reply #4 on: December 04, 2006, 18:14:50 »
Cheers for the responses.
It hasn't been curbed (unless SWMBO is keeping quiet) and only vibrates between 30 and 35. Nice and smooth below 30 and smooth after 35.

Offline Skibum346

  • Posts: 1975
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • T. A. N. S. T. A. A. F. L.
  • Referrals: 0
vibration
« Reply #5 on: December 04, 2006, 23:16:04 »
Steering damper coming to the end of it's life?

My Disco had the same problem around 40mph, changed the damper for an old man emu and it's now fine.

Skibum

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
vibration
« Reply #6 on: December 05, 2006, 00:50:25 »
Thew bit about throttle is significant.  I had a rear diff collapse and the early stages it was a bit like this :shock:

A UJ might be there all the time, might not but I don't think it would only disapear on overrun.

One nasty thought is something engine related, try it in deifferent gears to try and eliminate which side of the cogs it's occuring.
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.

Offline buster uk

  • Posts: 180
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
vibration
« Reply #7 on: December 05, 2006, 10:00:21 »
range rover blues ,
 I was getting a vibration at back about 3 weeks ago,4 days later a big clunk from the back and loss of drive.I took rear diff out and found the 4 planetry gears sat in the bottom of the axle casing  :shock:
Obviously a used diff was fitted,but what can cause this to happen ?
My front diff has been whining for ages but the back one was quiet until it just went bang ! It was full of oil also so not ran dry.
1994 Range Rover Classic 3.9 v8 vogue se

Offline chizy

  • Posts: 30
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Bloxham
  • Referrals: 0
vibration
« Reply #8 on: December 05, 2006, 20:02:22 »
Cheers for the suggestions fellas.
I am going to start with the basics.Going to drop the front prop and see what happens.If still there, try the rear etc
If it still does it, then what with the ABS still giving me s**t, anyone want a burnt out soft dash 300 Tdi????? :shock:
Still, gotta keep smilin'- it would be boring otherwise

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
vibration
« Reply #9 on: December 06, 2006, 00:27:22 »
Quote from: "buster uk"
range rover blues ,
 I was getting a vibration at back about 3 weeks ago,4 days later a big clunk from the back and loss of drive.I took rear diff out and found the 4 planetry gears sat in the bottom of the axle casing  :shock:
Obviously a used diff was fitted,but what can cause this to happen ?
My front diff has been whining for ages but the back one was quiet until it just went bang ! It was full of oil also so not ran dry.


I think bad luck really, usually a used diff is a known quantity, proved out if you like but you may have got one that had a nasty shock and weakend something, or it may have been weak since it was made.  One part failing will quickly take the others with it.  Unless there was a significant event shortly before it failed I'd say there wasn't much you could do to predict it.
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal