AuthorTopic: TDi engine breather, with air con  (Read 732 times)

0 Members and 1 Guest are viewing this topic.

Offline Lewis Bernard

  • Posts: 32
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
TDi engine breather, with air con
« on: January 21, 2007, 17:42:44 »
any ideas are welcome!

replaced/extended both axles, gearbox and transfer box breather pipes. With the air con models, the tensioner bracket/arm is the injector pump timing cover, thus i am unable to mount the after market plate on it for the timing cover breather. Can anyone see any issues with drilling and tapping the arm tensioner?

can you leave the wadding plaug in once a breather pipe is attached? and how about the gearbox one?

many thanks for the help guys.


lewis

Offline muddyjames

  • Posts: 3867
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
TDi engine breather, with air con
« Reply #1 on: January 22, 2007, 19:48:53 »
I will do a swap for my info for yours!!!

where on earth is the gearbox and Tbox breather bits as I cant find them anywhere.

My info now on the air con thingy.

the bracket your on about on mine the bearing wore out so I unbolted the bracket and put the right bracket on in its place.

My theory is if theair con was working the bracket would see the hole up so no water would get in. No idea why you would need a breather as I dont know what the timing cover hides. a watch perhaps?? :lol:  :?
Rover 620i 223,000 miles on the clock :)
1995 300tdi auto ES Disco. Big Green Giant

Most expensive item for a Disco is????? a round piece of paper stuck on the windscreen!

Offline Lewis Bernard

  • Posts: 32
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
TDi engine breather, with air con
« Reply #2 on: January 24, 2007, 17:00:21 »
Apparently the Tdi cover is for when a wadding plug is in place. I think that if the engine hits cold water it can be sucked in past various gaskets which are worn and arn't 100% perfectly sealed due to some sort of physics. I had both the idler and the tensioner bearings go on the air con pulleys as well, replaced them both.

your info! -

the gearbox and transfer box breathers are located behind the engine block at the top, right at the back of the engine bay - usually on the left hand side. They have curved ends (like a walking stick) and the same as the original axle breathers. Hope that helps. If you need any pictures i'm sure i can arrange something!

lewis

Offline muddyjames

  • Posts: 3867
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
TDi engine breather, with air con
« Reply #3 on: January 24, 2007, 19:12:13 »
photos would be good please. instructions came with photos and i couldnt line up the photos to under the disco.

i have my breather on the idler pulley area so thats cool it wont suck water in around other areas then :D. just no air con though :( my idler bearing went hence ok to replace with breather.
Rover 620i 223,000 miles on the clock :)
1995 300tdi auto ES Disco. Big Green Giant

Most expensive item for a Disco is????? a round piece of paper stuck on the windscreen!

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal