Pages: [1]   Go Down

AuthorTopic: Broken release lever?  (Read 788 times)

0 Members and 1 Guest are viewing this topic.

Offline Artwigwa

  • Posts: 162
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Broken release lever?
« on: February 25, 2007, 10:52:33 »
Hi all, Any ideas please?! The clutch pedel on my 90Td F reg only goes half way down and the release bearing is noisy. could this be a broken release lever? if so whats the best way to handle the gearbox to make room to fix?
Logged

Offline Artwigwa

  • Posts: 162
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
so here be the problem then...
« Reply #1 on: March 16, 2007, 09:00:52 »
This is what i found when i removed the gearbox...  :(

What could cause this?
Logged

Offline Leslie Henson

  • Posts: 67
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Broken release lever?
« Reply #2 on: March 17, 2007, 02:29:29 »
The thrust bearing has dried up and seized, then the friction generated by the thrust bearing rubbing, rather than spinning on the cover fingers has caused the plastic part of the thrust bearing to melt. This is quite a common occurrence. New clutch time I'm afraid.


Les.
Logged
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal