Fabricators

[Snooky]

I am after someone that can make a lump of metal into something I can use and not charge the earth for doing it  

I need a bracket making to hold the buckle end of some seat belts for the rear of my 90, so wil need to be strong enough for the job, but needs to be shaped so it will fit.
I can sort measurements and some drawings so just after an idea of who may be able to assist in this request.

Will be to lift the buckles about 5-6" off the floor  :)

[burgerman]

You have a p.m

[TDi90]

dont mean to hijack, but i need a metal rod making to hold up my bonnet. the old bar thing was bent and rubish. at the moment, use the end of an old broom handle!!
anyone point me in the right direction?
Rob

[Snooky]

Why not just pop to Challenger and see if they have any laying around, seem to have everything else there, if not, as basic engineering for this they can make one at a guess, mine will require a bit more bending and fabricating at a guess

This is kinda what I need http://www.fazer-mania.co.uk/coppermine/albums/userpics/10188/belt_bracket.doc

[muddymesser]

get a bit o metal n a blow torch a vise n a drill

maybe a hammer

heat then bend then drill then fit  :D  

its not hard

[MuddyMachine]

Rob,

Remind me tomorrow and ill see what I can do at work next week

Shouldn't be a problem.

Snooky if Burgerman cant help I might be able too :D

[TDi90]

cheeeeerrs!! ok! thanks baz!
c u tomorrow *excited + scared*

Rob

[hobbit]

dont mean to hijack, but i need a metal rod making to hold up my bonnet. the old bar thing was bent and rubish. at the moment, use the end of an old broom handle!!
anyone point me in the right direction?
Rob

Why not fit a hydraulic ram from the back of a hatchback

[Muddy]

Why not fit a hydraulic ram from the back of a hatchback

yep get down the scrappy for a pair and make 4 right angle brakets and pop rivet/bolt them to your wings/bonnet very kool and v handy :D