Pages: [1]   Go Down

AuthorTopic: Moving a 200tdi rad backwards.  (Read 809 times)

0 Members and 1 Guest are viewing this topic.

Offline ferret

  • Posts: 86
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Moving a 200tdi rad backwards.
« on: April 13, 2007, 17:50:25 »
Has anyone done this and how much work was involved. Because i have a full width intercooler in front i want to move them back to fit a close fitting winch and bumper.
Logged
aka paul*

Offline Xtremeteam

  • Regional Rep
  • *
  • Posts: 6476
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Its just the way i roll
    • lampeter, west wales
  • Referrals: 0
Moving a 200tdi rad backwards.
« Reply #1 on: April 13, 2007, 18:41:42 »
i did this to fit my FMIC along with a tight fitting winch on the front,
Moved the rad into the centre by an inch or so & then back 20mm to allow clearance,took a day to do it & had to make a new topframe to hold the rad
Logged
Mike
I can Drive.. You can criticize..
I too can criticize like you.. but can you Drive like me??

Offline ferret

  • Posts: 86
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Moving a 200tdi rad backwards.
« Reply #2 on: April 14, 2007, 00:06:14 »
So whats involved in it. Ill have a good look tomorrow . Ive got to move it back so that the intercooler is behind where the two cross struts in front of the rad used to be.
Logged
aka paul*
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal