Pages: [1]   Go Down

AuthorTopic: Engine  (Read 702 times)

0 Members and 1 Guest are viewing this topic.

Offline mungajeep

  • Posts: 2
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Engine
« on: April 13, 2007, 22:25:08 »
Hello , Would anyone be able to tell me what the cylinder head torque setting are for a Discovery 1 V8 Carb Model

Thanks[/b]
Logged

Offline Dr Neil

  • Posts: 818
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +1/-0
  • Referrals: 0
Engine
« Reply #1 on: April 13, 2007, 22:43:10 »
according to the workshop manual they are as follows:

outer row 54-61nm or 40-45lbft
centre row 88-95nm or 65-70lbft
inner row 88-95nm or 65-70lbft

hope this helps and good luck

Neil.....
Logged
200tdi over 200kmiles
+2"lift.
Procomp Es9000 shocks
235 MT's on silver modulars
diff guards
tank guard
Paidia4x4 winch bumper.
Discoparts HD rear bumper.
Champion 10000N winch
CB and CDplayer
Safari snorkel
modified turbo actuator vac pipe pick up.
twin batteries with Paidia4x4 split charge system
roof lightbar

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
Engine
« Reply #2 on: April 13, 2007, 23:12:42 »
Either sling the outer row (4) in the bin or torque them to about 25 LB/FT and thread lock them in.  All they do is warp the head and cause the gasket to fail.
Logged
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal