AuthorTopic: Oil Pressure Question???  (Read 828 times)

0 Members and 1 Guest are viewing this topic.

Offline Mutz

  • Posts: 733
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Norwich, Norfolk.
    • Norwich
  • Referrals: 0
Oil Pressure Question???
« on: May 13, 2007, 13:27:06 »
300tdi What sort of psi reading should i be getting at tickover and half throttle??

Haynes not to helpful as it just says between 25.0 - 55.0 at normal operating temp at operating speeds.
In which case what is my operating speed?
1995 300tdi 90 rebuilt and on the road (but still a project)
1992 Pajero SWB 2.5 Auto (failed its MOT and for sale if you want it)

"I Havn't got a Bad Attitude; you just can't handle my personality"

Offline Mutz

  • Posts: 733
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Norwich, Norfolk.
    • Norwich
  • Referrals: 0
Oil Pressure Question???
« Reply #1 on: May 13, 2007, 16:10:53 »
Oh come on someone must have a clue? :wink:

Dont any of you have an oil pressure gauge? :shock:

i need to know whether to take engine out and strip it, but its raining hard now so no rush :lol:
1995 300tdi 90 rebuilt and on the road (but still a project)
1992 Pajero SWB 2.5 Auto (failed its MOT and for sale if you want it)

"I Havn't got a Bad Attitude; you just can't handle my personality"

Offline Cassillis

  • Posts: 647
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Oil Pressure Question???
« Reply #2 on: May 13, 2007, 17:46:50 »
From the workshop manual:-

With engine running at idle check oil pressure,
which should read 1.76 bar (25.87 lbf/in2).

Hope this helps a little :wink:
Graeme
Avise~La~Fin

Offline Mutz

  • Posts: 733
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Norwich, Norfolk.
    • Norwich
  • Referrals: 0
Oil Pressure Question???
« Reply #3 on: May 13, 2007, 19:20:20 »
Thanks, going by that its an engine out job.
At idle getting about 5psi
1995 300tdi 90 rebuilt and on the road (but still a project)
1992 Pajero SWB 2.5 Auto (failed its MOT and for sale if you want it)

"I Havn't got a Bad Attitude; you just can't handle my personality"

Offline Cassillis

  • Posts: 647
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Oil Pressure Question???
« Reply #4 on: May 13, 2007, 20:03:50 »
Again from the manual:-

If pressure is low it can be caused by the
following:-
Thin or diluted oil.
Low oil in sump.
Choked oil strainer.
Faulty oil pressure relief valve.
Excessively worn or damaged oil pump
displacement gears.
Excessive crankshaft bearing clearance.

Sorry if this teaching you to suck eggs, good luck  :wink:
Graeme
Avise~La~Fin

Offline Mutz

  • Posts: 733
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Norwich, Norfolk.
    • Norwich
  • Referrals: 0
Oil Pressure Question???
« Reply #5 on: May 13, 2007, 21:17:30 »
bought it like this, apparently camshaft bearings.
but wanted to check pressure myself.
1995 300tdi 90 rebuilt and on the road (but still a project)
1992 Pajero SWB 2.5 Auto (failed its MOT and for sale if you want it)

"I Havn't got a Bad Attitude; you just can't handle my personality"

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal