Topic: Rubber rear prop shaft coupling ? (Read 752 times)

street_moto · « **on:** July 13, 2007, 20:36:43 »

Hi, was under the Discovery the other day greasing the UJ's and prop splines and noticed that the rubber rear prop shaft coupling was a bit tore up, so I ordered a coupling kit. It arrived today and comprises of the coupling, a bearing and three bolts with washers and nuts.
The coupling seems to be held in place with six bolts, three on the end of the prop and three on the flange of the diff output shaft, which ones do I renew?
Also I presumed that it'd just be a case of undoing bolts and inserting new coupling and bolting back up, the bearing suggests a bit more to it than that
Anyone done one?
What's the bearing for?

Regards Dave.

Budgie · « **Reply #1 on:** July 13, 2007, 23:34:53 »

No idea what the bearing's for, unless it's the bearing for the nose of the diff.
Normally I only buy the rubber bit and re-use the bolts.

Range Rover Blues · « **Reply #2 on:** July 14, 2007, 00:54:39 »

Is it a small round rubber lined bearing? if so it goes inside the end of the propshaft for the guide pin, when these wear no amount of new doughnuts will stop the vibration.

Steve ray · « **Reply #3 on:** July 14, 2007, 23:19:14 »

the rubber 'donut' is a pain (esp on lifted motors) .... ditch it and fit a rear from from a 200Tdi (and change outpu flange on diff to 4 hole)

Range Rover Blues · « **Reply #4 on:** July 15, 2007, 00:46:06 »

The other thing on a lifted motor is that you need a pair of UJs to cancel each other out

street_moto · « **Reply #5 on:** July 15, 2007, 00:53:03 »

Thanks for the input!
Managed to remove bolts at the coupling end and transmission end, but prop will not budge, think the splines may be seized!
If so how do I remove the prop?

Regards Dave

Range Rover Blues · « **Reply #6 on:** July 15, 2007, 00:56:48 »

You've got to take it off the back of the handbrake first as the support spigot goes a long way inside the prop, you'll understand what I mean once you've done the job

street_moto · « **Reply #7 on:** July 15, 2007, 10:15:25 »

Hi, yeah I get what you mean, but prop won't compress enough to allow me to remove it at the handbrake end.

Dave.

street_moto · « **Reply #8 on:** July 15, 2007, 17:32:05 »

Job done!

Removed grease nipple, blowtorch on prop, grease shot out under pressure, prop came out no bother after that!

Regards Dave

Range Rover Blues · « **Reply #9 on:** July 15, 2007, 18:17:20 »

Ah, too much grease at some point in it's life then.

News:

AuthorTopic: Rubber rear prop shaft coupling ? (Read 752 times)

street_moto

Rubber rear prop shaft coupling ?

Budgie

Rubber rear prop shaft coupling ?

Range Rover Blues

Rubber rear prop shaft coupling ?

Steve ray

Rubber rear prop shaft coupling ?

Range Rover Blues

Rubber rear prop shaft coupling ?

street_moto

Rubber rear prop shaft coupling ?

Range Rover Blues

Rubber rear prop shaft coupling ?

street_moto

Rubber rear prop shaft coupling ?

street_moto

Rubber rear prop shaft coupling ?

Range Rover Blues

Rubber rear prop shaft coupling ?