AuthorTopic: V8 temperature  (Read 731 times)

0 Members and 1 Guest are viewing this topic.

Offline stevepage3

  • Posts: 148
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
V8 temperature
« on: September 03, 2007, 17:38:55 »
Hi

Anybody running a 3.5v8 tell me roughly where their temperature gauge sits during normal on road jorneys, Mine was sitting at abouth half way, but after taking of the viscous fan it now sits at about 3/4 and the fan doesn't seem to be running as fast lost the jet engine sound when you first start her up.

Look forward tyo hearing from you

Steve

Offline doris

  • Posts: 75
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
V8 temperature
« Reply #1 on: September 03, 2007, 18:01:38 »
Still have my viscous fan, and know it works as I only hear it after a slog up a v big local hill.  My temp gauge sits just below halfway (by about a needle width) under virtually all circumstances, except when gunned up a hill that has the auto box hunting between 1st and 2nd under full power.......  by the top, the needle drifts just above halfway and the fan cuts in..........  then it sounds like an aircraft for 30 seconds to a minute before the needle falls to just below halfway again.

The only anomaly with mine is that I must have a slow opening stat because on initial warm up my needle drifts to just above half before falling to the usual spot.

Is it possible you have an airlock, or maybe a well clogged rad??

Hope that helps

Damon
'93 Disco v8 LPG

Offline burgerman

  • Posts: 1027
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 1
V8 temperature
« Reply #2 on: September 03, 2007, 18:07:43 »
This time of year mine runs between 1/4 and 1/2 under steady driving conditions, I have two 13" pacet electric fans which cut in just under 3/4  (also have a manual overide switch for wading)
  In warmer times it sits half way , But in the winter it runs 1/4

  It had a brandnew rad approx 5 months ago
  Hope this helps ???
TD5 with a few Tweaks ;o)
a bit more fuel friendly than the V8

Offline andygod

  • Regional Rep
  • *
  • Posts: 785
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Birmingham and surrounding areas regional Rep
  • Referrals: 0
V8 temperature
« Reply #3 on: September 03, 2007, 18:49:51 »
Mine sits at 1/2 way during winter & summer, it rises to about 3/4 when towing the caravan up a large hill but quickly falls back to 1/2 when on level ground.
Yo ho ho and a bottle of rum and jolly bad eggs are we

Offline Staffy

  • Posts: 115
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
V8 temperature
« Reply #4 on: September 03, 2007, 18:56:46 »
Mine is a 3.9 on lpg.

Stays @ just below midway only goes over that when going uphills or when off road sometimes, although the aircon fans are normally running alot more than I would like. Which is on my todo list to sort out.

Cheers
Phil
Gone but not forgotten
--------------------------------------------
Blue 94 V8i ES Disco, lpg L***LNM.
3" lift, 235x85x16 MT's on silver modulars, underbody protection, light bar, safari snorkel, twin optima batteries, 12000lb winch & heavy duty winch bumper, dog guard & more...
------------------------------------------------------

Offline gtomo2

  • Posts: 1924
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
V8 temperature
« Reply #5 on: September 03, 2007, 19:12:31 »
Mine sits just under the half way mark on petrol and just on the half way with lpg. it does go up slightly when i gun it on the motorway but never reaches the 3/4 mark. and still on vicous fan
Mr Graeme Thomas (tomo)
300 TDi Discovery - So i can go fording
Stop laughing put the camera down AND PASS ME THE TOW ROPE !! PLEASE

Offline stevepage3

  • Posts: 148
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
V8 temperature
« Reply #6 on: September 03, 2007, 19:28:32 »
Ok

Thanks for the replies,

So any suggestions as to why mine is getting so hot, have cleaned out the Radiator and checked water levels

any ideas,

Steve

Offline thermidorthelobster

  • Posts: 3557
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +1/-0
  • Referrals: 0
V8 temperature
« Reply #7 on: September 03, 2007, 19:34:18 »
My 101 used to sit on half way, even driving through the desert in 48deg heat weighing 5 tonnes.  I gather the viscous fan's more meaty;  101 owners with Kenlowes have had problems with keeping the heat down.
David French
Tree-hugging communist
1999 Discovery II TD5 Manual
Patriot roof rack, QT Services diff guards front & rear, DiscoParts steering guard[/url], Autologic ECU upgrade, 2" Old Man Emu lift, 235/85R16 BF Goodrich All Terrains, Safari snorkel, DiscoParts jackable sills, Warn Tabor 9000

Ex Disco 200TDI, P38a 4.6HSE and 101FC 6x6 Camper.  Africa Trip Blog

Offline Staffy

  • Posts: 115
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
V8 temperature
« Reply #8 on: September 03, 2007, 23:43:19 »
There are many reasons why a V8 will run warm.

But...

Re-reading your first post. If you have removed the viscous fan and refitted it and you do not have the noise then I think you need to check it is working.

When it is cold ie.. in the morning open the bonnet and spin the fan, it should turn easily. Run the engine until warm turn it off and then turn it again there should be considerable resistance now as the viscous coupling should have engaged. At least that's the theory.

If there is no / little difference then either it hasn't been put back right. Or it is borked :( and is probably the reason for the high temps.

If there is more resistance then we can rule out the fan and list other things to check / try!

HTH
Phil
Gone but not forgotten
--------------------------------------------
Blue 94 V8i ES Disco, lpg L***LNM.
3" lift, 235x85x16 MT's on silver modulars, underbody protection, light bar, safari snorkel, twin optima batteries, 12000lb winch & heavy duty winch bumper, dog guard & more...
------------------------------------------------------

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
V8 temperature
« Reply #9 on: September 04, 2007, 12:27:52 »
Actually when you first start the car the fan should be a bit stiff, all the fluid runs out into the vanes and locks the hub up.  

As it spins the oil is firced into the reservoir and the fan then idles.  When it gets warm the valve opens and allows the fluid back into the vanes, locking the fan up.

So you should hear it at startup and you should hear it when things get hot. All other times I would expect it to sit halfway, that's what your thermostat is for!

Having had problems with the LSE overheating I spoke to Kenlowe.  They advised that as I tow 2 tonnes regulary that I shoulkd NOT remove the viscous in preferance to twin electrics as they DON'T move anywhere near as much air.

I have replaced the rad last night, the viscous (though if anything the new one seems to slip even more), fitted a Kenlowe auto box cooler, hosed out the airconn rad and added some water wetter, just for good measure.

I'll let you know how I get on.
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal