Help!!! Range will not start, no spark!!!

[yellow series 2a]

Please help.
My 1988 rangie 3.5 V8 will not start i have fuel flow but no spark out of the coil. So i replaced the coil with a new one and still no spark i have power going to the coil but no HT out. Any thought??

Many thanks

[mentalmoshio sophs V8i]

mite be the crank  sensor in the dizzy gone . replacement dizzy is the only  answer. maybe

[yellow series 2a]

Thanks thats what i am thinking is gone

[Bowie]

Ignition amplifier?

From memory it should either be on the wing next to the coil or on the side of the dizzy with either two or three wires going to it -much much much cheaper than a new dizzy.

Check the reluctor clearance inside the dizzy as well.....


Plus ALL wires -these can get easily broken just through wear and tear...

HTH,

Bowie.

[Oli-L]

I had the same problem with mine changed the coil, dizzy, rotor arm, and put on brand new leads on her, turned out to be sum little ecu white box under the drivers seat, gave it a waggle and it started first fick of the key :roll: so i changed that and shes bein fine since! Give that a try, you never know!!

[mentalmoshio sophs V8i]

the sure way to find out is with autologic check local mate does it for 30 quid.

[Range Rover Blues]

I'm thinking ignition ampliefier too, but make sure the battery is topped right up, mine won't start either if the battery is a bit too flat.

[yellow series 2a]

Thanks very much for your hep am going to change the ignition ampliefier hope this shoulg fix it
Many thanks