ARRRRRG! Can someone help, I have been tinkering and now the Rangie doesn't work. :(
I started off this morning by putting on the new starter, pain in the arse job, but it is done. To see if I had connected it up ok I started her up and she ran fine. I let her warm up whilst I cleaned the tools, and I stopped and started her about a dozen or so time to make sure everything was ok. Job done I retired triumphantly for a cup of tea and discovered the posty had been
. On the doorstep was my new lucas dizzy cap and rotor arm. Feeling buoyant I decided to fit that as well. I removed the orignal dizzy cap and rotor, put the new ones on, connected the HT leads IAW the workshop manual and found that the [!Expletive Deleted!] wouldn't start. I checked the HT leads, the coil leads etc were connected correctly and still nothing. I then put the old dizzy cap and rotor on, connected it correctly again and found, interestingly enough, that it still won't start. The coil fires a strong blue spark and I am positive that I have the HT leads in the correct order.
Any Ideas?
