Topic: 3.5 V8 lost all power... (Read 5158 times)

v8rangie · « **on:** March 15, 2008, 17:11:34 »

Right finally got my Bobtail on the road and was geting around 5 MPG :shock: :shock:

So i cleaned the engine through with 10k boost (de-coker) and was running fine for about 10 mins till it started spluttering and lost all power.

so i cleaned all the elec connections inc dizzy etc...

and stil the same. it will start and tick over fine but as soon s you put your foot down it takes a few seconds to get to about 1600 rpm and that is it. and i cant drive it at all there just isn't enough power to move the truck.

So i replaced to fuel pump which aint cheap and still nothing.

put some redex in the fuel and still exactly the same.

but went out today and now it wont tick over. it will fire but will cut out almost straight away.

any more ideas???

i have fitted new plugs, leads, dizzy and arm a few months ago.

Also tried a working ecu the other day but still the same....

Range Rover Blues · « **Reply #1 on:** March 15, 2008, 17:29:05 »

Timing or ignition fault. Timing would explain the low MPG and the poor starting.

v8rangie · « **Reply #2 on:** March 15, 2008, 20:21:19 »

but it was strange that it suddenly lost power.

the only ignition part left to replace is the coil but could that cause the trouble?

ben_haynes · « **Reply #3 on:** March 15, 2008, 20:30:33 »

yes it could be the coil but it could also be the vaccum pipe on the dizzy advance/retard bit fallen off or split

v8rangie · « **Reply #4 on:** March 16, 2008, 15:46:13 »

Checked the vacuum pipe on the dizzy today and all fine no blocks or splits.

But now it wont start at all not even try to fire... :(

sean m · « **Reply #5 on:** March 16, 2008, 16:01:37 »

Is it on carbs or injection retrace your steps what you done since it last ran fine do a compression check, check dizzy is clamped tight check points for spark.Dont take for granted that new parts put on work fine i found this out with a new condenser that was duff.

ben_haynes · « **Reply #6 on:** March 16, 2008, 16:23:43 »

Quote from: sean m on March 16, 2008, 16:01:37

Is it on carbs or injection retrace your steps what you done since it last ran fine do a compression check, check dizzy is clamped tight check points for spark.Dont take for granted that new parts put on work fine i found this out with a new condenser that was duff.

POINTS !!!!!!!!!!

it has an ECU it wont have Points and it will be EFi

mine is Carb and that does not have Points

v8rangie · « **Reply #7 on:** March 16, 2008, 16:46:27 »

yeah its efi.

well the only thingi done is cleaned the engine through with de-coker.

and since has lost all power but now decided not to start.

im gonna get a coil and a air flow meter as it was running gas and apparently they break down after a while..

Range Rover Blues · « **Reply #8 on:** March 16, 2008, 16:58:50 »

Actually a coild would do that yes, mine did something similar, it would start but we all know the V8 will run on 5 if it has to, but I had no power and after a couple of minutes it was undriveable.

I carry a cheap spare now.

v8rangie · « **Reply #9 on:** March 16, 2008, 17:48:01 »

gonna have to get one asap nd hope it solves the problem i only been on 1 outing since its on the road... :'(

MonsterLandrover · « **Reply #10 on:** March 17, 2008, 13:16:11 »

Have you tried the temp sensor for the ecu? just on top of the inlet manifold. mine did that and it turned out to be the temp sensor.

v8rangie · « **Reply #11 on:** March 17, 2008, 18:51:11 »

well my temp guage doesn't work anyway so i need to get tht sorted to know whats happening with the engine while driving.

Range Rover Blues · « **Reply #12 on:** March 17, 2008, 19:01:49 »

Temp guage sender and ECU temp sensors are both near the thermostat and can be checked with a multimeter.

v8rangie · « **Reply #13 on:** March 18, 2008, 18:19:19 »

thought they were down there.

the top of the inlet is something to do with the fuel aint it?

Range Rover Blues · « **Reply #14 on:** March 18, 2008, 18:24:57 »

On the EFi, yes all the wired up bits are for the EFi, if yours is a 3.5 then IIRC you have a cold start injector.

v8rangie · « **Reply #15 on:** March 19, 2008, 17:39:21 »

puta new coil on it today and will fire but will not run..

any more ideas?

Gonna change the air flow meter next and see if that does anything.

Range Rover Blues · « **Reply #16 on:** March 20, 2008, 03:28:55 »

Is it 3.5? or 3.9 hot-wire?

mikiep1986 · « **Reply #17 on:** March 20, 2008, 11:23:50 »

was on landy zones forum said about your problem bro andsomeone has come back saying it sounds like a whole engine rebuild. and another said about your dizzy ??

v8rangie · « **Reply #18 on:** March 20, 2008, 17:48:15 »

Its the 3.5..

Mike dont say that i dont fancy putting a new engine in..
its oly done 50k ish...

What did the say about the dizzy? its a new cap and arm. and just cleaned the vaccum advance out to.

Range Rover Blues · « **Reply #19 on:** March 21, 2008, 03:19:23 »

If it's the 3.5 then you need to thorouoghly check all the sensors on the EFi now, do you have the Haynes manual?

v8rangie · « **Reply #20 on:** March 21, 2008, 06:40:03 »

Yeah i have a haynes.

im picking up another complete Range rover today to swap all the bits over till it works and so i have a load of spares.

squaddie_fox · « **Reply #21 on:** March 21, 2008, 11:39:08 »

mine did exactly this. tried everything you have. eventually got it driveable. BUT..............you need to check your valley gasket. if the rubber or the gasket are knackered, like mine, you can get it running etc. then when you are on the motorway, it all goes bang! well lots of smoke and some little bangs. when i stripped the engine (3.5 efi) the intake system was full of oil, and i tracked it all down to the rubbers on the valley gasket being perished. even though the engine had apparently been rebuilt!

v8rangie · « **Reply #22 on:** March 21, 2008, 12:55:11 »

well i didnt get the other rangie as it was a carb model.

but i have spent another couple of hours clening sensors and stuff and i have now given up im gonna pay someone to fix it now its getting right on my nads.....

Range Rover Blues · « **Reply #23 on:** March 22, 2008, 03:38:59 »

Well if they fix it the fuel economy will save enough money to pay the garage bill ;)

v8rangie · « **Reply #24 on:** March 22, 2008, 07:30:38 »

Yeah thats true.

im gonna tell him if its gonna cost me hundreds then dont bother. ill just convert it to diesel or just drop a 3.9 in :)

Pete5844 as was · « **Reply #25 on:** March 22, 2008, 13:20:54 »

When mine fired but wouldn't start the RAC bloke removed the fuel pump relay and replaced it with a fuse,started straight away.Pete

burgerman · « **Reply #26 on:** March 22, 2008, 15:58:16 »

i runa bottle of injector cleaner through the system on 2 occasions, and on 2 occasoins had to replace a injector due to being blocked, ( i reckon loose/cleanes lump of curd caused it) any how after replacement all run fine, Worth a thought????

Range Rover Blues · « **Reply #27 on:** March 23, 2008, 03:01:08 »

Quote from: burgerman on March 22, 2008, 15:58:16

i runa bottle of injector cleaner through the system on 2 occasions, and on 2 occasoins had to replace a injector due to being blocked, ( i reckon loose/cleanes lump of curd caused it) any how after replacement all run fine, Worth a thought????

Good point, I'm undecided on oil flush for that reason :-k

Pete5844 as was · « **Reply #28 on:** March 23, 2008, 18:33:02 »

Years ago I used oil flush on a v6 Ford,sounded like a sack of spanners afterwards.Pete

v8rangie · « **Reply #29 on:** March 25, 2008, 21:14:17 »

well its all fixed and running sweet now.

it turned out to be a mixture of a few things.

the air pipe from afm to inlet had imploded basically cutting the air supply causing it to over fuel.

which killed the plugs.

And the remainder of the lpg which was still connected was playing up so all that came out and a new set of [plugs went in and he fired straight up and is running very very well now.

News:

AuthorTopic: 3.5 V8 lost all power... (Read 5158 times)

ben_haynes

ben_haynes