RRC brake system diagram

[paulmmc]

Hi,
I'm nearing the end of the rebuild of my 1987 RRC 3.5 V8 Efi, with only a disctinct lack of brakes stopping me going for a drive. While I am happy enough to plumb all the pipes and that, I have been looking for a good schematic diagram of the layout. The Haynes manual shows a very basic one with the primary and secondary circuits but doesnt show pressure reducing valves etc. Anybody have a good diagram to make sure i dont miss any important bit?

Thanks.

[Lewis.J.P_1987]

Hey,
I have the complete Rave manual for the car, what exactly do you need?

[paulmmc]

That would be great.

Basically i need an idiots guide of what should connect to where. There are 4 outlets from the master cylinder, and 4 inlets into the fron two claipers and 2 into the rear calipers, so where in the runs should i be installing pressure reducing valves, T pieces, etc, if any are required.
A good schematic diagram should do the trick if possible, so that i have something to check my work against.

Thanks, paul

[paulmmc]

I had a look for the Rave file last night in t'interweb and found exactly what i was looking for, I can't believe i've done so much work without it, it is really good!
But this is the picture i was looking for.



Cheers

[Lewis.J.P_1987]

Yes if found it really useful especially when sorting out the EFI system on my truck.