Pages: [1]   Go Down

AuthorTopic: inner door seal  (Read 7853 times)

0 Members and 1 Guest are viewing this topic.

Offline dimoven

  • Posts: 55
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
inner door seal
« on: April 05, 2005, 17:33:27 »
Is it easy to replace the rubber inner door  seal on a disco 1( driver side)?
Do I simply remove the old one and slip the new one, on or is sealant needed to fix the new rubber in place any suggestions appreciated.
Logged

Offline muddyweb

  • Posts: 6382
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
inner door seal
« Reply #1 on: April 05, 2005, 18:10:43 »
Not difficult at all.  Just pull the old one off and the new one fits in its place.

You don't need any special glues or sealant
Logged
Tim Burt
Muddyweb
-------------------------------------------------------------------------------------------------------------------
www.muddyweb.com
-------------------------------------------------------------------------------------------------------------------

Offline Andy.

  • Posts: 3289
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
inner door seal
« Reply #2 on: April 05, 2005, 18:40:46 »
Did my drivers door one last year, 10 minute job max.

Pull the old one off and replace with the new. Best to start in a corner I found and tapped it lightly all the way around with a hammer.
Logged
Andy Member # 8






My Webshots  (updated 19.06.05)
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal