Pages: [1]   Go Down

AuthorTopic: disco roll cage  (Read 839 times)

0 Members and 1 Guest are viewing this topic.

Offline deepdive

  • Posts: 2
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
disco roll cage
« on: December 11, 2009, 00:41:15 »
people
im new to mud club so need advice, im needing a roll cage and need to know if anybody has any contacts in the highlands to make one for  me,  i live in fort william
i have a disco 1 that has some mods on it , lifted, pro comp's, axle and steering guards, sliders, so i want to turn it into a comp racer.
spoke to Henry from muddy moo cheers mate, and yes told richard where i found out about the doors.
any advice to get it ready would be appreciated.
regards

Louis
Logged

Offline lambert

  • Moderator
  • ***
  • Posts: 2137
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +1/-0
  • and then as if by magic
    • harrogate
  • Referrals: 0
Re: disco roll cage
« Reply #1 on: December 11, 2009, 05:01:21 »
not local but for a ready built look at safety devices or if not then get the design from the arc rule book and have it made by a local certified welder/fabricator.
Logged
Lambert Coverdale.

As slow as possible, as fast as necessary.

Two and a half litres of turbocharged diesel goodness.

Offline Skibum346

  • Posts: 1975
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • T. A. N. S. T. A. A. F. L.
  • Referrals: 0
Re: disco roll cage
« Reply #2 on: December 11, 2009, 09:17:50 »
Not sure who it is (maybe power & performance) but there is a company out there who do flat pack cages. You (or a good welder) put it together.

Check out the landy mags adverts...

Skibum
Logged
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal