AuthorTopic: Disco 300 v8 problems when started  (Read 1314 times)

0 Members and 1 Guest are viewing this topic.

Offline stevepage3

  • Posts: 148
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Disco 300 v8 problems when started
« on: February 23, 2010, 12:17:06 »
Hi

I have just acquired a Disco 3.9 v8 when you first start it up it seems to hunt with the revs going up and down, once you rev it  a couple of times it seems to settle down. Is this normal ?

Steve

Offline morson4x4

  • Posts: 392
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Salisbury
  • Referrals: 0
Re: Disco 300 v8 problems when started
« Reply #1 on: February 23, 2010, 12:29:46 »
does this only happen when first morning start or on every start
One Life, Live It

Offline stevepage3

  • Posts: 148
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: Disco 300 v8 problems when started
« Reply #2 on: February 23, 2010, 13:18:43 »
seems to be every start

Offline morson4x4

  • Posts: 392
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Salisbury
  • Referrals: 0
Re: Disco 300 v8 problems when started
« Reply #3 on: February 23, 2010, 14:36:39 »
my old v8's used to pop and mis-fire and struggle to pick revs up like u said rev up or in my case was choke, and it was fine i thought all v8's did it, possible check you plugs to see if the mixture is still ok could be bad plugs, ht leads. or try seeing your local garage and get a proffesional opinion and see what there guesses are
One Life, Live It

Offline Rossko

  • Posts: 297
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: Disco 300 v8 problems when started
« Reply #4 on: February 24, 2010, 18:11:21 »
Muck out the idle stepper motor plunger and its housing as the first action
GLASS

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
Re: Disco 300 v8 problems when started
« Reply #5 on: February 25, 2010, 01:08:22 »
Hey, if it starts every time and runs fine once started, who cares?

Seriously though, the stepper motor controls the idle speed IF the throttle plate was set up properly, often they are bodged by incompetant LPG installers!

Also the EFi will run a fast idle if it detects a low voltage during cranking, to put a bit of charge back into the battery.
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal