Pages: [1]   Go Down

AuthorTopic: schutz gun  (Read 914 times)

0 Members and 1 Guest are viewing this topic.

Offline Saffy

  • Posts: 3127
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +1/-0
    • The Bell Inn, Imber.
  • Referrals: 0
schutz gun
« on: June 21, 2010, 16:23:07 »
Is there a trick to getting a schultz gun started? Not used one before and took awhile before it suddenly started spraying and I am not sure exactly what I did other than a combination of turning it upside down (to prime?),putting my finger over the breather hole and swearing at it for a bit.  The schultz/waxoyl/solvent solution I am using is well runny so don't think it was that (unless too runny?)
« Last Edit: June 21, 2010, 17:27:45 by Saffy »
Logged
.swonk eno oN .esoht dna eseht ,siht dna taht ,wollof ot selur emos teg eW

Offline topless matt

  • Posts: 503
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: schultz gun
« Reply #1 on: June 21, 2010, 17:03:58 »
I found with mine that the pickup pipe was just a touch too long and with the can fully screwed on the pick up pipe stuck to the bottom  :evil:
Took me ages to work it out and then cut the pipe at an angle and it works fine now, you will be suprised how little solvent you need, mine sprays neat waxoyl with no trouble at all............... 12 bar  8-[
Logged
300tdi, southdown snorkle, tubular bumper, tds winch with dyneema, tree sliders, 6 spotlights, creepy crawler tyres, 2" lift, dislocation cones, dropped mounts all round, wide angle propshafts, mud dash, bucket seats

Likes to eat badgers
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal