Mud-club

Chat & Social => The Bar - General Chat => Topic started by: hobbit on September 24, 2005, 19:22:58

Title: Gunsons Testune, instructions?
Post by: hobbit on September 24, 2005, 19:22:58

I have one of these things, mostly only been used for volt testing,
..Silicon-chip multimeter


It has a 6 point rotary switch, for rpm, dwell, volts, points, ohms and amps

Below from ledft to right, High low switch, Ohms adjust & rotors/cylinders switch

The leads are, (this is where the fun starts)
Red ok thats pos, Black thats neg got them

The other 2 are the ones and how to connect them up for testing with they are,
black wire with a blue plug on it, and
black with red stripe wire with a green plug

Anybody got some instructions for this thing,

Title: Gunsons Testune, instructions?
Post by: Reaper on September 24, 2005, 19:28:29

We do Gunson stuf where I work, if you still need them on tuesday let me know and I'll see what I can do  :wink:

Title: Gunsons Testune, instructions?
Post by: hobbit on September 24, 2005, 19:50:13

Thanks Peter

Was looking at setting up my mates s3, but just plani forgot how to use it connection wise, except for volt testing, handy on the indicators being an analog meter :wink:

Title: Gunsons Testune, instructions?
Post by: Reaper on September 28, 2005, 23:55:30

Kev if you still need those instructions I photo copied them @ work today.
 :lol:

Title: Gunsons Testune, instructions?
Post by: hobbit on September 30, 2005, 08:51:47

Yes please just tripped over the flaming thing again, makes a good paperweight at the moment