Mud-club

Vehicle & Technical => Defender => Topic started by: Range Rover Blues on November 11, 2005, 17:55:45

Title: 200TDi axles
Post by: Range Rover Blues on November 11, 2005, 17:55:45

I'm trying to fit 200TDi half shafts in to my front axle but nothing seems to fit, so I've swapped the half shafts, stub axles, hubs and now I've got a wheel back on the centre cap pops off, so Does anybody have alloys on their 200TDi and if so which ones?

Title: 200TDi axles
Post by: Xtremeteam on November 11, 2005, 18:46:02

does the hub have a slit stamped in the end of the studs?

If not shouldnt fit alloys to the motor

Title: 200TDi axles
Post by: Range Rover Blues on November 11, 2005, 20:45:13

Yes they have the slot marked on the end and on first glance they are the same as the RRC hubs, the studs are the same lenght, same castings, it's just the bearings sit further apart so I've had to swap the vented disks from the Rangie onto these hubs.