Mud-club

Vehicle & Technical => Range Rover => Topic started by: way2deep on November 27, 2005, 19:22:46

Title: def bumper pics + lift
Post by: way2deep on November 27, 2005, 19:22:46

at last a piccy.notice the bumper sits on top of chassis

Title: def bumper pics + lift
Post by: barmiebrumie on November 27, 2005, 19:31:09

Done something similar the weekend too will try to get some pic's tomorrow when i'm at work & have more time to spare :wink: ,

looks nice thou

Title: def bumper pics + lift
Post by: gtomo2 on December 10, 2005, 18:07:25

can you give us any info on fitting the bumper and how close is the winch to the rad looks good my go down that street myself as it will increase the approch angle

Title: def bumper pics + lift
Post by: way2deep on December 10, 2005, 19:45:56

yes mate, the bumper was put on top of chassis rails,then 6mm plates welded vertically to the underneath of the bumper ,running on the  inner side of the chassis rails.if you look closely you can see the nearside one jutting out from the chassis rail.the original bumper holes were used and a bolt put vertically thru each chassis rail at the rear.winch  sits near rad but not too close ..hope this helps. p.s see def shot 2 for sie view

Title: def bumper pics + lift
Post by: gtomo2 on December 10, 2005, 19:51:21

cheers will be looking into doing that in the new year