Mud-club

Vehicle & Technical => Series Land Rovers => Topic started by: paul_g on December 16, 2005, 15:34:46

Title: Replacement Bulkhead
Post by: paul_g on December 16, 2005, 15:34:46

This question has probably been asked a million time before, but.... Is it possible to modify a 90 bulkhead to fit a series 3?? Mines not in great shape, but i know where i can get hold of a good priced new 90 one. Cheers all.

Title: Replacement Bulkhead
Post by: Miniman on December 16, 2005, 17:50:46

Why not replace all the rusty parts and have a new series bulkhead...
Replacment pannels are not expensive....

Try here http://www.landroverspares.co.uk

Title: Replacement Bulkhead
Post by: paul_g on December 16, 2005, 17:58:21

Thanks, I had thought of that. Mine is going at the top corners and looks as though it has been patched before. Is it an involved job repairing them at hat location? Or would it just be easier and better in the long term to replace the whole thing?

Title: Replacement Bulkhead
Post by: Miniman on December 16, 2005, 20:35:20

If you take the wings off and the doors you have a very good access to most of the sides. Its a big job to replace the whole thing. You have all the wiring loom to disconnect to start with and on a series its a big job then all the rest off the pain in the a*se things to start on.... I would have a look at it first and see what access you have. I took the wings off floors out and doors off to do mine.....alot easyer

Title: Replacement Bulkhead
Post by: Lee_D on December 19, 2005, 00:18:04

Lorra piccys on here, worth a thousand words as they say!

http://www.lrproject.com/jlo/index.html

tis a sub section of my site. Click Home and It'll take you to my main page if your having a dull half hour or so.

Lee D