Mud-club

Vehicle & Technical => Series Land Rovers => Topic started by: paddymoo on May 31, 2006, 10:03:13

Title: help! propshaft UJ fouling the nuts that hold it there!
Post by: paddymoo on May 31, 2006, 10:03:13

help!

this is driving me nuts! well, more to the point its not driving anywhere...

i have nearly finished my swb s3 / s2 rebuild.  i say s3 / s2 because its a kind of mish mash, with what i think is a series two chassis, and the rest is s3 bits.

anyway, i have just  put the rear propshaft  on,  and the universal joints are fouling against the bolts that hold it in place, meaning that the propshaft wont  do a full revolution.

its not fouling against all of them, but they are all the same size nuts. i have tried swapping the propshaft around, but still the same problem. i have also tried packing the end of the gearbox with a couple of washers to space it all out a bit, but this hasnt helped.

i am sure i have the right propshaft, probably, but someone must have some idea what is going on with this!

please help....

paddy

Title: help! propshaft UJ fouling the nuts that hold it there!
Post by: Neil Jones on May 31, 2006, 12:52:02

I'm not quite sure I understand correctly, but if I am understanding, try putting the bolts the other way through the holes.

Title: help! propshaft UJ fouling the nuts that hold it there!
Post by: paddymoo on May 31, 2006, 13:04:46

cant turn the bolt round as it is fouling at the gearbox end, where there are captive bolts in place for you to screw the nuts on to.

does that make it any clearer, oh, and its the rear propshaft, not the front one.

Title: help! propshaft UJ fouling the nuts that hold it there!
Post by: mark.yellow.series.3 on May 31, 2006, 19:01:24

a pic will help.
what about grinding the bolts down a little?

Title: help! propshaft UJ fouling the nuts that hold it there!
Post by: ian_s on May 31, 2006, 19:53:11

how have you got the vehicle at the moment? is the back axle fully drooped by any chance? cos mine bind when i do that.
once its on its wheels its fine

Title: help! propshaft UJ fouling the nuts that hold it there!
Post by: LANDYTIM on May 31, 2006, 20:08:46

are the UJ's all operating properly and no worn needle bearings?

Title: help! propshaft UJ fouling the nuts that hold it there!
Post by: paddymoo on June 05, 2006, 14:17:08

thanks guys.

it was me being stupid, and indeed it was just because the back wheel wasnt fully dropped.

doh!

and it took a full days work to get that sorted out!