Mud-club

Vehicle & Technical => Range Rover => Topic started by: turbonutter on June 13, 2006, 21:09:49

Title: crunching in 1st and 2nd !!!!!
Post by: turbonutter on June 13, 2006, 21:09:49

iv a prob on my 95 2.5 range
if u select 1st and 2nd it crunches , if u change really slow u can change without the crunch but its now anoying !!bbb :x
it will also jump out of 1st when pulling off but only sumtimes
has any1 had this ,whats ur idears ??

cheers guys bb

Title: crunching in 1st and 2nd !!!!!
Post by: hobbit on June 13, 2006, 23:10:16

Apart from the obvious of a shot gearbox, when was the oil last changed on it, you could try some additive, but with it jumping out of gear it sounds like another unit for it, or a strip down and replace the offending items

Title: crunching in 1st and 2nd !!!!!
Post by: turbonutter on June 20, 2006, 17:03:25

ill give it an oil change as iv no idear when it was last done , might make it a bit beter !
prob gona be the sincromesh on the first 2 gears tho ?

Title: crunching in 1st and 2nd !!!!!
Post by: mark.yellow.series.3 on June 21, 2006, 22:03:43

sounds like the baulk rings are worn, i have the same prob in second gear.
basically its a worn out gearbox, have reconned or buy another.

Title: crunching in 1st and 2nd !!!!!
Post by: turbonutter on June 23, 2006, 19:41:15

im gona try a oil change at the weeend be4 i do anything else.
when the cars cold its ok and will only start crunching when its warm

Title: crunching in 1st and 2nd !!!!!
Post by: Range Rover Blues on June 24, 2006, 21:57:08

So it's worse when the oil heats up and goes thin? got to try an oil change first then.  Try some additive too.