Mud-club

Vehicle & Technical => Series Land Rovers => Topic started by: TUFFTEE on July 03, 2006, 23:48:35

Title: vin plate
Post by: TUFFTEE on July 03, 2006, 23:48:35

anyone tell me where the vin plate is hiding on a series 2a please
thanx in advance.....

Title: vin plate
Post by: 22900013A on July 04, 2006, 14:52:08

Should be on the bulkhead somewhere, on round heater models its sort of above the gear lever, on later ones with a square heater its in the dash by the steering column.

Title: vin plate
Post by: mark.yellow.series.3 on July 04, 2006, 19:28:59

the plate on my s3 was a piece of plastic under the bonnet!
but cars pre 1980 dont need a manufactures vin plate so just stamp your own.

Title: vin plate
Post by: Cheggs on August 07, 2006, 18:16:45

should the chassis be numbered on a series 2a? if so where? The vin plate on mine is on the bulkhead.

Title: vin plate
Post by: Rich_P on August 07, 2006, 21:05:24

Front right dumbiron on the driver's side of the dumbiron.  That's where the Series 2A chassis number is stamped on the chassis.

Title: vin plate
Post by: Cheggs on August 08, 2006, 18:50:45

strangely There appears to be aplate weled ed over that location, My SIIa is starting to look my Lemonish, I shall grind it off and find out.

Title: vin plate
Post by: Rich_P on August 08, 2006, 20:10:30

Dont be surprised if it is missing.  If the front dumbirons have been repaired or replaced, then it is likely the chassis number has gone from there.