Mud-club
Vehicle & Technical => Discovery => Topic started by: barmiebrumie on July 25, 2006, 22:31:08
-
Well I think I found where the water was coming in :shock: ,
Not as bad as it looks only took 2 hour's to get the old floor out cleanded up ready for the new one & should take about the same to get the new steel welded in tomorrow night, took two of us 9 hour's on saturday (both experiecnced panel beaters) to cut out the inner & outer sill's & make new one's (nice & flat now) bring on the MOT :twisted: ,
Found a whole family of LR spider's (LARGE spiecies) living behind the side trim's, have rehomed them behind the dash for now :wink:
John.
-
Well I think I found where the water was coming in :shock: ,
Not as bad as it looks only took 2 hour's to get the old floor out cleanded up ready for the new one & should take about the same to get the new steel welded in tomorrow night, took two of us 9 hour's on saturday (both experiecnced panel beaters) to cut out the inner & outer sill's & make new one's (nice & flat now) bring on the MOT :twisted: ,
Found a whole family of LR spider's (LARGE spiecies) living behind the side trim's, have rehomed them behind the dash for now :wink:
John.
wow u got aircon too u lucky sod :lol: :lol:
-
Look's better now don't you think :lol: , only took two of us 4hr's :roll: , now to get all the seat's & carpets back in as i took them out & took them to work to get them steam cleaned,
John
-
did you make up the floor pan yourself :?:
Havent seen one with out all the ridges etc before
-
Made it from sheet steel, now the carpet's back down you woud never know :wink:
John.