Mud-club
Vehicle & Technical => Discovery => Topic started by: ktrangersfc3 on August 07, 2006, 19:12:27
-
hi all can anyone help me out here the indicaters on our disco stuck on but when you take out the fuse for the hazerds/warning lights the indicaters work fine. Is it that the wire has rubber through some where down the line? just thought i would ask
regards phil
-
I would try a new flasher unit ?
-
Have you tried turning the hazard switch on-off several times? I would think the hazard switch is broken in a position just between on-off. Holding the switch in can cause a temporary fix, which would also confirm you need a new hazard switch.
-
sorry i should have said it is the o/s indicaters sticking on not both duz this make any diffrence? if u pull out the hazzard switch the light still stays on.
-
:? when you say staying on do you mean flashing/steady/ or steady but slighlty dimmer than norm???
-
:? when you say staying on do you mean flashing/steady/ or steady but slighlty dimmer than norm???
it is on steady.
-
Flasher unit kaput replace this .....if not new indicator stalk
Darren
-
Flasher unit kaput replace this .....if not new indicator stalk
Darren
If the flasher unit is at fault when removed should the light go out?
if so the light is staying on.
-
:? does it go off with ignition? or stay on permanent? also take down the steering column covers and un plug the stalk see if it goes off then??
-
it stays on permanent the only way to get it off is to pull the fuse out i will try n take out the flasher switch.