Mud-club

Vehicle & Technical => Range Rover => Topic started by: mark.yellow.series.3 on August 17, 2006, 19:41:12

Title: SU's settings, lots of poping on overun
Post by: mark.yellow.series.3 on August 17, 2006, 19:41:12
well trucks pretty much done, but engine feels a bit slow, also exhaust smells very rich, and it pops and bangs on over run.

i havnt had the carbs balenced yet, and when it went for MOT the garage adjusted the mixture to how it should be, but it would barley drive, so riched it up and it drive 'ok'. when you pull the choke out it goes like a rocket.

any ideas guys.



ps, its running K&N's and a short sports exhauste.


thanks in advance.
mark.
Title: SU's settings, lots of poping on overun
Post by: thermidorthelobster on August 17, 2006, 21:29:24
Mine popped like crazy on over-run when the exhaust was leaking causing pressure problems.  I'm no expert but check your sports exhaust?

Try balancing them the manual way - stick a pipe in each intake, in exactly the same place, and the other end in your ear, and adjust until the sound's equal.  Sounds horribly inaccurate but I've found it's not too bad to do with practice.

Did the exhaust smell rich after you riched it up, or when the mixture was correct?
Title: SU's settings, lots of poping on overun
Post by: mark.yellow.series.3 on August 18, 2006, 22:20:23
Quote from: "thermidorthelobster"
Mine popped like crazy on over-run when the exhaust was leaking causing pressure problems.  I'm no expert but check your sports exhaust?

Try balancing them the manual way - stick a pipe in each intake, in exactly the same place, and the other end in your ear, and adjust until the sound's equal.  Sounds horribly inaccurate but I've found it's not too bad to do with practice.

Did the exhaust smell rich after you riched it up, or when the mixture was correct?


it smells rich after i riched it up (no s**t :oops: ), when it was at the right mixture it woulnt drive hardley.
Title: SU's settings, lots of poping on overun
Post by: Grunter on August 24, 2006, 23:05:55
Did you get to the bottom of this??

 Sounds like its leaking air on the manifold somewhere if its popping on the over-run.
SimplePortal 2.3.5 © 2008-2012, SimplePortal