Mud-club

Chat & Social => The Bar - General Chat => Topic started by: davidlandy on September 02, 2006, 19:09:40

Title: today we have been mostly............
Post by: davidlandy on September 02, 2006, 19:09:40

Fitting a disco 200 tdi engine into a td 90 .

downed tools due to hunger

Title: today we have been mostly............
Post by: Xtremeteam on September 02, 2006, 19:30:18

should be running by now  :lol:

did you use a steve parker exhaust or fab your own downpipe?

Title: today we have been mostly............
Post by: davidlandy on September 02, 2006, 19:36:59

got a steve parker one - didnt fancy spending a week trying to fabricate one!

just got to chop out the inner wing now to give some room for the intercooler hoses, and work out  the routing.  

then still got to make up an air filter assembly

and sort out the clutch feed pipe as i chopped it off the bulkhead at the bracket but i have to work out how best to secure it.

oh, fuel pipes to extend as well so that the filter can be secured on the bulkhead

....and the glow plug wiring

......and the rad mount to chop down

..........and chop down the exhaust to meet up with the SP downpipe

.............and theres probably more!


any useful tips on this will be greatly appreciated!

Title: today we have been mostly............
Post by: landyman Ash on September 02, 2006, 19:58:23

Quote from: "RedlineMike"

should be running by now  :lol:

Got mine running in a day, must be slacking  :wink:

Its all the little bits that take the time.  

Oh and that and the dam local pub calling from distance........ :P

Title: today we have been mostly............
Post by: davidlandy on September 02, 2006, 20:10:30

hey you boys, it would easily be running today (but not complete)  but we dont have the radiator as its away being repaired

so there!

Title: today we have been mostly............
Post by: landyman Ash on September 03, 2006, 12:04:27

Excuses excuses......  :wink: