Mud-club
Vehicle & Technical => Discovery => Topic started by: scouse lanny on September 24, 2006, 19:42:48
-
hi there can anyone help a friend has just fitted a 2 inch lift kit with blue springs and pro comp shocks but it has pushed the front up but the back hasent changed do u think they have sold him wrong springs
-
Could be rear anti roll bar pulling it down? If he still has it fitted. Took mine off when i fitted a 1 inch lift as it didnt sit right with it on
-
he did put the right ones on the front and back ???? small at the front large at the rear :D
-
he did put the right ones on the front and back ???? small at the front large at the rear :D
was just gonna say that :lol:
-
i was thinking they could off just give them any ones wont b going there again :lol:
-
defo wrong way round lol
-
take it off and check the overall sizes from the origional ones, if they are bigger jack the shassis up and make shure the axel droppes enough. you may have a siezed centre linkage, theres 2 bars going from the axel at the back that go up onto the body area just infront of the fuel tank. i had this problem and the springs were ok. after a good douse in wd40 and a trip to waddon it freed itself.....just a thought :wink:
-
i was thinking they could off just give them any ones wont b going there again :lol:[/quote]
where did ya get them from ????????????????? bearing in mind too that if they are pro comp springs they should be marked up n/s and o/s for the front springs ...also the o/s spring is fractionally longer than the n/s one
-
no thehocks a pro comp i think the springs ar bear mach but he said there was no difference in height on all the springs when he got them i thought the bac should b longer it was lr centre in liverpool