Mud-club
Vehicle & Technical => Discovery => Topic started by: drmike on September 24, 2006, 20:23:18
-
Simple question. Will an R380 gearbox and attacjed transfer box from a 90 fit a Discovery as a more or less straight swap?
Thanks
Mike
-
if it's anything like the LT77 the bell housing will be different along with the selector mechanism on top of the gearbox....
hope this helps
Neil.....
-
the R380 box in a defender is the same IIRC if it comes of a 300 tdi,if its anyother engine its different i think
-
Thanks Mike it's just that there sometimes R380 boxes + transfer boxes on eBay and I'd like to know I can bid with some confidence of fitting them!
Mike
-
I'm sure I've read somewhere that the selector position was on a different place on the 90 box compared to the disco.
Isn't the gearstick located further back on the Disco box? :-k
I could be wrong though! :wink:
-
Whose a little ray of sunshine?
Now you mention it I seem to recall that as well.
Mike
-
Doesn't the 90 transfer box use a different ratio to the discovery one ? Seem to remember driving a disco that had a defender transfer box, it did about 65 mph tops !
Worth checking out !
-
different gear ratio and im not 100% but i dont think the 2 are interchangeable, without mods, im sure the disco box is longer.
-
Doesn't the 90 transfer box use a different ratio to the discovery one ? Seem to remember driving a disco that had a defender transfer box, it did about 65 mph tops !
Worth checking out !
different gear ratio and im not 100% but i dont think the 2 are interchangeable, without mods, im sure the disco box is longer.
Pete;
yes thats true,a disco uses a higher T box ratio of 1.22 in high but in lowbox they are the same,very doubt a disco doing 65 flat out as at the moment i have my 90 on 205's (disco size :wink: ) running a defedner tbox (1.410 ratio) & does 70mph,BUT what you are saying is true.
Guardian,that was the case on the 90/110 range that used the LT77 box,the disco LT77 has a longer bellhousing to put the engine forward where as the 300tdi defender & disco the engine is forward on both models & the gearbox has the same long bellhousing,,the only difference to the 2 boxes which i got mixed up on is the levers are the other way round on a disco,BUT the box itself length wise etc is the same
-
I have a 300Tdi in my defender project with a Disco R380. The engine is in the correct position and when it came to the gear remote I needed to cut out a section of the seat box. The seat box and tunnel I bought from a breaker and were also from a 300 Tdi defender.
-
ahhhhh, now im gutted as i turned down a defender box proper cheap from a good source as i thought it needed [!Expletive Deleted!] about with to fit!
not to worry, learn something every day.