Mud-club

Vehicle & Technical => Discovery => Topic started by: Arightpest on October 31, 2006, 16:33:27

Title: radius arms
Post by: Arightpest on October 31, 2006, 16:33:27

hello all  

does anybody know if the radius arms are the same on a 200 tdi as a defender because i have been given a set to enable me to get the bushes replaced on the defender ones so i can do a straght swap to save time.

mick

Title: radius arms
Post by: Budgie on October 31, 2006, 18:28:55

Measure the width of the arms where the bushes go in on the axle end as I seem to remember that there is/was a difference at some point.

Title: radius arms
Post by: bullfrog on October 31, 2006, 21:27:27

Most 90s came with narrow arms and rangies/discos had the wider type.
I dont know if defenders went over to the wider type.
But they are easy to see the difference.
Some had smaller thread ends too so check these as you would need the bushes as well.

Title: radius arms
Post by: Range Rover Blues on November 01, 2006, 14:46:21

I think the early RRC had the smaller threads and narrower axle bushes, these migh also be the early One-Ten types but with the introduction of the EFi models the thicker and better arms were introduced.  For a Disco you need the later RRC ones or possibly later Defender.