Mud-club

Chat & Social => The Bar - General Chat => Topic started by: Guy90 on November 12, 2006, 22:17:30

Title: Anyone know where I can get these from?
Post by: Guy90 on November 12, 2006, 22:17:30

Looking for a supply of Hexagonal 5/16UNF (Thin) nuts?

Anyone know any suppliers out there?

Title: Anyone know where I can get these from?
Post by: Paul on November 12, 2006, 22:29:21

Guy,

I might be able to help.

Now many do you need ?

Title: Anyone know where I can get these from?
Post by: Guy90 on November 12, 2006, 22:32:11

Quote from: "Paul"

Guy,

I might be able to help.

Now many do you need ?

Paul,

Ideally 4 or 5 but 2 would be fine.

Thanks

Title: Anyone know where I can get these from?
Post by: Paul on November 12, 2006, 22:59:22

I'll let you know tomorrow... I'll have a look in the store. :wink:

Title: Anyone know where I can get these from?
Post by: Guy90 on November 13, 2006, 00:07:30

Quote from: "Paul"

I'll let you know tomorrow... I'll have a look in the store. :wink:

Paul,

Thanks. That would be great.

Title: Anyone know where I can get these from?
Post by: Paul on November 13, 2006, 12:58:22

Got some in the store that are 6mm high..

Any good to you.. or do you need to go thinner ?

Title: Anyone know where I can get these from?
Post by: Guy90 on November 13, 2006, 13:24:53

Paul,

Just had a measure and they need to be 3mm.

Maybe I could cut one in half? :shock:

Title: Anyone know where I can get these from?
Post by: hobbit on November 13, 2006, 14:41:51

Or grind them down :wink:

Title: Anyone know where I can get these from?
Post by: Paul on November 13, 2006, 17:01:32

If you want to give it a try I could post you a few.

Title: Anyone know where I can get these from?
Post by: Ja1983 on November 13, 2006, 17:36:49

3mm? would be worried about thread stability at such a thickness.... glue not an option?  :lol:

Title: Anyone know where I can get these from?
Post by: Evilgoat on November 13, 2006, 17:42:04

thread a nut on, cut em, clean up and pull the nut off again, job's a good-un.

Its possible that there might be some in my Grandfathers workshop if these dont, not sure I'd be able to find them if they arent labelled though :)

Title: Anyone know where I can get these from?
Post by: Guy90 on November 13, 2006, 19:40:09

Quote from: "Ja1983"

3mm? would be worried about thread stability at such a thickness.... glue not an option?  :lol:

Normally so would I. However these are used as adjusters and need to be a specfic size.

Happily I have found a supplier.

Paul,

Thanks for having a look :D  :D