Mud-club

Vehicle & Technical => Discovery => Topic started by: dazzawhipple on November 22, 2006, 14:42:22

Title: Output Shaft bearings
Post by: dazzawhipple on November 22, 2006, 14:42:22

I have a Discovery 200TDI with a leaky output shaft seal on the transfer box

But after investigation the bearings are shot so i need to replace them

How do I do it do I have to split the transfer box apart or can i do it from the outside

Thanks

Darren

Title: Output Shaft bearings
Post by: Range Rover Blues on November 22, 2006, 14:51:45

By transfer box out put I assume you mean the prop shafts.  If so it can be done with the box still in the car but I'm not sure how as I run a B-W.

Title: Output Shaft bearings
Post by: dazzawhipple on November 22, 2006, 15:22:23

RRB

Its the bearing behind the oil seal actully in the transfer box!!!

Darren

Title: Output Shaft bearings
Post by: Range Rover Blues on November 22, 2006, 15:35:53

D'oh.  Then I'm not sure :roll:

Title: Output Shaft bearings
Post by: extreme90 on November 22, 2006, 20:50:06

front or rear ?
or have i missed it where you said  :oops:

Title: Output Shaft bearings
Post by: dazzawhipple on November 22, 2006, 22:10:45

Both ...mind you I have just done the rear

Whats the best way to flush crap oil out its a bit murky to say the least!!!!!


Darren