Mud-club

Vehicle & Technical => Series Land Rovers => Topic started by: Hangover on December 20, 2006, 21:39:23

Title: S111 stuck in gear
Post by: Hangover on December 20, 2006, 21:39:23

I've just purchased a S111 109 which is stuck in gear,can somebody tell me the cause.
Thanks,
Kev

Title: S111 stuck in gear
Post by: Dr Neil on December 20, 2006, 22:18:26

will it come out of gear without the engine running?If you try and start the engine without depressing the clutch does it try and leap forward?

Title: S111 stuck in gear
Post by: Hangover on December 20, 2006, 22:28:06

We havn't had the engine running yet and the clutch pedal is on the floor,the gear lever is solid though,you can't budge it.
Kev

Title: S111 stuck in gear
Post by: ian_s on December 22, 2006, 14:04:32

my gearbox did this to me while i was driving it. stuck solid in 3rd
i just changed the box in the end, and i intend to rebuild that one to keep as a spare.

what gear is it stuck in?

Title: S111 stuck in gear
Post by: Hangover on December 22, 2006, 18:08:51

Seems that we were lucky and it required just the top cover removing and the selector rods moving,fingers crossed.
Kev

Title: gearbox
Post by: moggs on January 03, 2007, 19:19:26

while you have the top cover off, heres a job for you.  get some emery paper and lightly sand the detent spring channels and keep trying the plungers in the casing for fit these should be a nice fine sliding fit.
also do not tighten the top cover fully or you will crush the casing and nipping the detent bearings.
doing this will make the fitting easier and will change gear better
hope this helps
moggs

Title: Re: gearbox
Post by: Hangover on January 03, 2007, 21:10:27

Quote from: "moggs"

hope this helps
moggs

Cheers.
Kev