Mud-club

Vehicle & Technical => Series Land Rovers => Topic started by: MonsterLandrover on January 30, 2007, 19:41:28

Title: HOT series 3 lighting switch
Post by: MonsterLandrover on January 30, 2007, 19:41:28

i have recently put a halogen conversion on my series and have noticed that the light switch gets hot when the lights are on. is this usual??

Title: HOT series 3 lighting switch
Post by: AbyssDJ on January 30, 2007, 19:46:13

have you got higher wattage bulbs in it?

Title: HOT series 3 lighting switch
Post by: MonsterLandrover on January 30, 2007, 19:48:24

No. there 55/60w

Title: HOT series 3 lighting switch
Post by: AbyssDJ on January 30, 2007, 19:51:36

hmm... could be just because its old and not up to it i suppose. just rewire them with a relay and it should be fine

Title: HOT series 3 lighting switch
Post by: Bob Ajob on January 30, 2007, 22:13:52

Hi,

A halogen conversion should not be used without a relay, you are sending all the power needed for the lights through the light switch, and when on full beam through the indicator stalk.

The relay is switched by the light switch, and then it transfers all the power from the battery straight to the lights. It may be costly it if burns out the switch and/or cables.
Have a look here Vehicle Wiring Products (http://www.vehicle-wiring-products.co.uk/), you should find something suitable. It's not a difficult job, will take about an hour or so.

Regards,
Rob.

Title: HOT series 3 lighting switch
Post by: dave_2A_2.25Turbo on January 30, 2007, 23:20:43

I've used conversions on 3 Minis, 2 260Zs, a Jensen Healey and my 2A with no problems (or relays)  I'd suggest either a bad earth or a dodgy switch (in that order)