Mud-club

Vehicle & Technical => Discovery => Topic started by: POTASH on January 31, 2007, 17:31:39

Title: clutch problem
Post by: POTASH on January 31, 2007, 17:31:39

my clutch pedal seems to go after about 2 months, hard to change gears without crunching, then when i bleed it its ok again, no fluid loss, it seems like air gets in, any ideas :?

Title: clutch problem
Post by: J.D. on January 31, 2007, 17:44:23

Have you checked the clutch master cylinder, it could be on its way out?

Title: Re: clutch problem
Post by: redhand on January 31, 2007, 19:02:45

Quote from: "POTASH"

my clutch pedal seems to go after about 2 months, hard to change gears without crunching, then when i bleed it its ok again, no fluid loss, it seems like air gets in, any ideas :?

Sounds like the slave cylinder had the same problem on my 110.

Title: clutch problem
Post by: POTASH on January 31, 2007, 21:02:37

thanks i will check it out :wink:

Title: clutch problem
Post by: extreme90 on January 31, 2007, 23:20:32

id say just replace both then it eliminated them

Title: clutch problem
Post by: dazzawhipple on February 01, 2007, 07:40:56

I have just replaced mine Master and slave .....then found out its the friction plate rusted on the flywheel

Darren