Mud-club

Vehicle & Technical => Discovery => Topic started by: BigA on February 17, 2007, 10:06:45

Title: Another ABS issue
Post by: BigA on February 17, 2007, 10:06:45

ok, my abs light is on in my 1995 300TDI Disco, now i think its because one of the front sensors is not seated correctly, therefore too big an air gap? But...... i found the ABS blink test in the workshop section, and thought, yes great i can do that, printed it off, and off i went to do the test. Found ABS relay no problem, disconnected as instructed, opened up the drivers side fuse panel to locate the blue diagnostic plug, and here is my problem, i cant find it, or anything looking similar.

Any suggestions please, i thought this was going to be too easy  :?

cheers in advance,

Andy

Title: Another ABS issue
Post by: Range Rover Blues on February 18, 2007, 01:04:34

I went looking for the EFi plug opn my softdash and I had to remove the underside kick panel and unwrap it fromm the loom.  If it has never been used it might be trapped alongside the wiring as it was installed, worth a look.

If you can't find it I can look on the Rovacom help pages for you, pm me if you get stuck.

Title: Another ABS issue
Post by: BigA on February 18, 2007, 08:36:52

Quote from: "Range Rover Blues"

I went looking for the EFi plug opn my softdash and I had to remove the underside kick panel and unwrap it fromm the loom.  If it has never been used it might be trapped alongside the wiring as it was installed, worth a look.

If you can't find it I can look on the Rovacom help pages for you, pm me if you get stuck.

Thanks mate i will take another look, i didn't want to start tugging on looms unless sure it would be there, i will take another peek.

Title: Another ABS issue
Post by: Matbrown on February 22, 2007, 11:06:36

Mine didn't have one either, looked everywhere for it!


Mat.

Title: Another ABS issue
Post by: BigA on February 22, 2007, 18:11:11

Quote from: "Matbrown"

Mine didn't have one either, looked everywhere for it!


Mat.

hmmmmm...... could be fun resetting the error then  :?

Title: Another ABS issue
Post by: dazzawhipple on February 22, 2007, 19:19:25

Put a bit of tape over the bulb






only joking

Title: Another ABS issue
Post by: Matbrown on February 23, 2007, 01:21:41

Quote from: "BigA"

Quote from: "Matbrown"

Mine didn't have one either, looked everywhere for it!


Mat.

hmmmmm...... could be fun resetting the error then  :?

I had to get it on the machine at LR.


Mat.