Mud-club

Chat & Social => The Bar - General Chat => Topic started by: L90OOK on March 20, 2007, 16:33:40

Title: Which Plasma Cutter??
Post by: L90OOK on March 20, 2007, 16:33:40: I want to get myself a plasma cutter for chassis, bodywork & fabrication of my own vehicles.
However...I have no experience of these machines :roll:
So...Your input on a good machine would be welcome...cheaper the better too :?
Cheers
Title: Which Plasma Cutter??
Post by: Bulli on March 20, 2007, 17:03:02: these things never seem to go cheap, no doubt someone will no where you can get one though!
Title: Re: Which Plasma Cutter??
Post by: muddydisco on March 20, 2007, 18:44:21: Quote from: "L90OOK"
I want to get myself a plasma cutter for chassis, bodywork & fabrication of my own vehicles.
However...I have no experience of these machines :roll:
So...Your input on a good machine would be welcome...cheaper the better too :?
Cheers

Which one are you thinking of going for the one with the built in compressor or not. I would go for the one with the built in compressor. There one called the drag-gun picture of a dragon i here these are great.

It's on ebay item numer 280093846256
Title: Which Plasma Cutter??
Post by: Xtremeteam on March 20, 2007, 18:59:45: got a snap on one which runs of the garage compressor,wasnt cheap looking at Ã‚Â£500 to buy it 2nd hand now & over 1k new
Title: Which Plasma Cutter??
Post by: L90OOK on March 20, 2007, 19:12:25: Cheers guys

I was looking at under Ã‚Â£500 if possible...I have a compressor so either machine would be ok.
Have been looking on flea bay but don't know the pros & cons of each machine! :?
What sort of Amperage sould I be going for?
Thanks