Mud-club

Vehicle & Technical => Range Rover => Topic started by: sardonicus on June 16, 2007, 14:32:37

Title: New covers on old seats
Post by: sardonicus on June 16, 2007, 14:32:37

Looking for advice about putting some seat covers,front,(original covering not over covers)from an '89 4door RRC onto earlier 2 door seats with inertiabelts on frame.Willthe back panels(from 4 door) fit on the frame?I know i'll have to make holes for tilt levers and belts where they come out the top and the head rest is different.
Would it be easier to fit the inseat older belts onto the later frame?i mean does the later frame have mountings for belts and could a tilt mechanism be fitted?
Thanks,I've tried to explain it the best  i can!
pic. of 4 door seats.
will 4door seats fit on the 2door bases?
Thanks.

Title: New covers on old seats
Post by: Range Rover Blues on July 02, 2007, 13:01:18

Don't know the answer to that one but a set of 4 doors seats will cost you the fuel to fetch them, so if you have a spare 2 door seat you might as well try, there is no such word as can't.

Title: New covers on old seats
Post by: sardonicus on July 02, 2007, 20:49:11

Thanks for reply,was hoping you would be along with some advice! :wink:
Will get some cheap grey 4door seats and see what fits what.

Title: New covers on old seats
Post by: jjsaul on July 03, 2007, 09:30:34

i had a couple of sets of 4 door grey seats through my hands and you cant give them away!  2 seats went to the tip in the end  :shock: