Mud-club
Vehicle & Technical => Discovery => Topic started by: Steven on August 22, 2007, 22:53:19
-
Hi everyone,
Bought a straight through exhaust middle part, got told it was a straight fitment to your stoke ehaust system, just measured it and its too short by a couple of inches. How can we get sround this? Could I use some flexi pipe in between the straight through and where it joins on the rear box section? Thanks in advance.
-
Can you losen the clamps on the rear section an slide it back enough for it too fit?
-
Can you losen the clamps on the rear section an slide it back enough for it too fit?
Could do I'm not sure...
-
If it's the wrong one then take it back and get the correct one.
I've seen a few of these for TD5 Discos, make sure it's not one of these and is built for a 300 series. :wink:
-
If it's the wrong one then take it back and get the correct one.
I've seen a few of these for TD5 Discos, make sure it's not one of these and is built for a 300 series. :wink:
The bloke don't sell anymore. Not replying either to my emails.
-
I wonder why! :?
In that case then try your local exhaust fitters and see if they can come up with a suggestion. They may have some scrap pipe laying around that will do the job. :wink: