Mud-club

Vehicle & Technical => Discovery => Topic started by: winx on September 09, 2007, 16:43:08

Title: Clutch Alignment tool
Post by: winx on September 09, 2007, 16:43:08

I am changing the clutch on my 200tdi Disco next weekend and need a clutch alignment tool.  

Can anyone make any reccomendations for this?  Cheers

Title: Clutch Alignment tool
Post by: MuddyMachine on September 09, 2007, 17:21:45

Deep socket, Cant remember size sorry

Title: Clutch Alignment tool
Post by: Disco-Ron on September 09, 2007, 20:39:07

I've done loads of clutches, and have never ever used one, i actually did borrow one when i did the disco clutch, but none of the bits fitted..... they weren't big enough... so did what i always do, looked into the middle and did it by eye...!!!

Title: Clutch Alignment tool
Post by: clbarclay on September 09, 2007, 21:30:01

Done it a few times by using a shaft and rapped duct tape round it to build it up to the right diameters.

Title: Clutch Alignment tool
Post by: andyb on September 10, 2007, 21:13:52

Quote from: "MuddyMachine"

Deep socket, Cant remember size sorry

Deep 15mm socket with insulating tape wrapped around one end worked a treat for me :)

Title: Clutch Alignment tool
Post by: Xtremeteam on September 10, 2007, 21:21:26

find a gearbox input shaft works for me :lol:  :lol:

Title: Clutch Alignment tool
Post by: hobbit on September 11, 2007, 20:54:32

Socket extension bar and masking tape :wink:

Title: Clutch Alignment tool
Post by: freeagent on September 11, 2007, 21:12:11

i've got the end off a gearbox input shaft... works a treat.

Title: Clutch Alignment tool
Post by: Disco-andy on September 11, 2007, 23:15:05

22mm copper pipe, worked a treat for me

Title: Clutch Alignment tool
Post by: extreme90 on September 11, 2007, 23:33:47

my eyes never let me down yet  :P  :P
works for me  :twisted:

Title: Clutch Alignment tool
Post by: Henry Webster on September 12, 2007, 16:43:13

I use the shaft of one of those wooden meat tenderisers! :lol:

Can't think where that came from - not likely to see the kitchen again now its too useful.  Was also perfect for drifiting out the spigot bearing!

H