Mud-club
Vehicle & Technical => Defender => Topic started by: suggs on September 18, 2007, 10:39:53
-
ive got no diff lock light, checked bulb and its fine. had a look at the switch on the transfer box and theres 12v going into it but only about half a volt coming out. dosent change when i engage or disengage the lock. just got this 90 so i cant really be 100% sure if its working just by driving it. low and high works fine.
any ideas what i could check..
cheers
-
Have you driven in difflock or just selected it stationary :?:
i ask because the light only comes on when difflock engages not when it;s selected.
It;s the same when disengaging the light will not go out strait away.
cheer's DM
-
yea drivern with it engaged..
-
That's a shame it would have been a nice easy answer :cry:
-
sorted it, the switch is stuffed, jacked up a front wheel and it locks and unlocks fine..
cheers
-
you have tried adjusting the switch down i take it ?
they do ware over time on the tip and wont illuminate even tho diff lock is in
dan
-
nope dont no how to do that, just looks like it screws into the T/Box, is there ajustment if i take it out??
cheers
-
theres a locknut onit further down 14mm afink :?
undo that and screw the switch down half a turn at a time
try that 1st
its the same switch as the reverse light one
dan
-
ok ill have another look, but it didnt look like it had a lock nut, looked to be all one piece, one long nut about an inch or so long sat flush againts the t/box with two wires coming off it, its under the centre pannel between the seats, or am i looking at something else lol...
-
the difflock light switch is located just behind the actuator
thats behind the front prop, above but behind if you get me :P
i cant see my difflock light swtich from the center panel removed, i can only see the reverse light switch
dan
-
are must be the reversing switch i was looking at then "Doh"