Mud-club

Vehicle & Technical => Series Land Rovers => Topic started by: graham on October 31, 2007, 00:16:05

Title: Lightweight wheels
Post by: graham on October 31, 2007, 00:16:05

I have a lightweight after selling the RR, the deal was i got the wheels and grizzly claws back. Will the RR wheels fit the lightweight or am I better to do someone a swap for some spoked steel rims?

Title: Lightweight wheels
Post by: Range Rover Blues on October 31, 2007, 01:12:53

I have a sneaking suspicion they might, because your drive meber doesn't stick out as far as a series.

But I'm sure someone will actually know the answer :wink:

Title: Lightweight wheels
Post by: graham on October 31, 2007, 19:30:48

I suppose the only way is to try em, i got the wheels back but no nuts so i'll have to get a set of them if they fit.

Thanks for the reply  :D

Title: Lightweight wheels
Post by: whittlesey35 on November 03, 2007, 13:56:47

i have 235/85/16 gripedge broncos fitted on disco alloys they run fine on my 1983 lightweight

Title: Lightweight wheels
Post by: graham on November 04, 2007, 01:02:22

Thanks for the reply that sounds positive  :D

Title: Lightweight wheels
Post by: Xtremeteam on November 04, 2007, 11:43:00

is it rangie alloys or rangie rostyles?

alloys "should" but wouldnt & the rostyles dont without a bit of modification

Title: Lightweight wheels
Post by: graham on November 06, 2007, 23:18:38

They came off my RR classic I'm not sure, as far as i know they're standard wheels.
Just walking past the lightweight today i noticed I'll have to mod the exhaust where it comes out behind the wheel.

I must put antifreeze in it too  :shock: