Mud-club
Vehicle & Technical => Defender => Topic started by: marjan on November 07, 2007, 19:19:37
-
Advice please on how to mount a cubby box in a Defender 90. Only way I can see is to mount it to the plate between the seats and the screw the plate back in place, is this possible?
-
i drilled through the cubby box and plate then attached the nut's from underneath.
only way i could figure it out :roll: :roll:
-
Iv'e got the one from scorpion racing and it came with a mounting bar with theaded bar welded to it .It was just a case of drilling holes and getting under the 110 and doing the bolts up .Took me about 1-2 hours.
-
2 tech screws through bottom o the cubby box into the allly plat underneath, no crawling about fafing about with bolts n washers & needing some1 else to help you
took me about 15 min
-
My old 90V8-CSW actually had threaded inserts in the centre cover-plate :shock:
But, both 110's have had to be drilled & the boxes bolted on
-
i drilled through the cubby box and plate then attached the nut's from underneath.
only way i could figure it out :roll: :roll:
Yep, that's what I have ended up doing too, seems strong enough.
By the way, I may know you as I used to live on Towngate.
-
i drilled through the cubby box and plate then attached the nut's from underneath.
only way i could figure it out :roll: :roll:
Yep, that's what I have ended up doing too, seems strong enough.
By the way, I may know you as I used to live on Towngate.
quite possible Iwas born on what used to be Chapel st, behind the old co-op and raised on Teall st
-
I used some of the plastic captive nuts used for the floor sections in the plate. Just had to drill, then file out to square to fit them. Then used the same screws as the floors through the base of the cubby box. They are dirt cheap, even from a main stealer!
-
By the way, I may know you as I used to live on Towngate.
Digressing, one of out Nurses has just bought a house off Towngate