Mud-club
Vehicle & Technical => Discovery => Topic started by: paul.p on December 02, 2007, 22:42:03
-
got a brake pull to the right on my 300tdi, when had tyres changed last week found grease on back of n/s front disc and on pads, swivel leaking... today i cleaned all grease up, had disc off, no grease left on that, fitted new pads, but still got brake pull.so thinking poss by a sticking caliper?? so if gotta change caliper are 200/300 ones same? and read something about 110 calipers being a good swap? help please!
-
are you sure it was the swivell causing the fault . usually its the inner wheel brg seal which causes this. the pads are then well contaminated. think i left mine in genclean then swapped 1 with the other side . alan.....
-
well i just guessed the swivel as it is pitted and covered in grease too.....
another job on list, just need to get brakes sorted as its my daily motor
-
my swivel went like that but it didnt get on the pads , have a good check im pretty sure youl find its the inner brg seal. was a pig when mine went, good luck. alan.....
-
Yes 110 callipers should fitas they are single circuit like yours. Make sure you get the vented ones though if you have vented disks!
-
I had sticky caliper problems with my Disco, I eased the pistons part way out gave them a good clean. Popped them back in making sure the seals where good. I haven't had any problems since.
-
been thinking today.. when fitted the pads, the pistons went back in easy so not sure if caliper or not now.... :?